This is a drop-in stock replacement aFe performance air filter that installs into your BMW's factory airbox. This particular filter fits the following BMWs:
This version has an oil-free filter media for less maintenance. For the best flowing filter, with the best performance gain, we always recommend the standard aFe "Pro5R " filter (which has a blue pre-oiled filter media), but this oil-free filter flows only slightly less than the blue Pro5R style aFe filter, and requires no re-oiling after cleaning the filter.
This is a drop-in stock replacement aFe performance air filter that installs into your BMW's factory airbox. This particular filter fits the following BMWs:
This version has an oil-free filter media for less maintenance. For the best flowing filter, with the best performance gain, we always recommend the standard aFe "Pro5R " filter (which has a blue pre-oiled filter media), but this oil-free filter flows only slightly less than the blue Pro5R style aFe filter, and requires no re-oiling after cleaning the filter.
Replacement mass air sensor for the M60/M62 engine. This HFM is an OEM part, made by Bosch (Bosch #0 280 217 800).
The M60 engines have a notorious fault for hesitation and sluggish response. If this is your situation the MAF should be on your list to check. The HFM is easy to replace and could cure a variety of problems.
This sensor is also known as the "540 HFM" that is used in a variety of OBD-1 E36 M3 upgrades.
This replacement HFM fits the following BMWs:
1993-1995 E34 BMW 540i
1997-1998 E39 BMW 540i
1988-1994 E32 BMW 740i 740il
1995-1998 E38 BMW 740i 740il
1990-1999 E31 BMW 840i 840ci
CRC HFM cleaner is specifically developed to clean mass air flow sensors. Increases horsepower & improves air/fuel ratio and MPG. Plastic safe-dries in seconds! Perfect for cars that have had "over-oiled" performance filters installed. Over-oiling can cause the HFM to gum up, this is the perfect solution. This item cannot ship air freight or internationally. UPS Ground shipping to the lower 48 US states only.
Replacement ITG Foam Filter for Conforti Intake Kits. Available in 3" and 3.5" opening (see below for applications) or check your filter box for correct appliaction. Filter
comes pre-oiled but oil recharge kit is recommended for future maintenance.
Click here for approved cleaning methods for ITG foam filters.
Applications:
3.5" (blue box): all Euro HFM kits (E36 M3, MZ3), E46 330, late E46 325, E39 530, E39 540, Z3 3.0
3.0" (green box): all other models not listed above (E36 M3/MZ3 with stock HFM, E36 325/328, E46 323/328, E39 525/528, Z3 2.3/2.8)
Don't use harsh solvents like gasoline to clean your ITG on your Eurosport/Conforti intake kit (or similar foam filter element). This product is all you need to maintain your ITG foam filter, and is recommend for use with all Conforti Cold-Air Intake Kits.
When cleaning an ITG foam filter, ITG recommends using warm water and a mild detergent (simple dish soap is fine). Strong detergents and solvents can harm the foam, and cause the filter to break down. Once dirt, dust and debris are rinsed out of the filter, it should be re-oiled to ensure proper function of the filter. ITG recommends No-Toil filter oil, as it is safe to the foam filter media, and is completely waterproof. Drive with more peace of mind through heavy rain and puddles.
Please note, as this product is an aerosol, it MUST BE SHIPPED BY UPS GROUND. Sorry, this can not be shipped outside of the US/Canda.
BMW 8 Series
aFe Performance Air Filters
This is a drop-in stock replacement aFe performance air filter that installs into your BMW's factory airbox. This particular filter fits the following BMWs:
