BMW E93 M3 H&R Coil Over Suspensions

H&R is the original German coil over manufacturer - designing and testing coil overs from their base in Sauerland. H&R began by producing high-quality springs for motorsports and rally. Then grew to include high-performance street vehicles and later engineering their springs to work within custom-designed shock absorbers to form high-performance coil over suspension kits. Each kit is designed in-house, tested extensively (including the Nurburgring) and produced with quality materials. Every H&R coil over is TUV tested and approved and ISO certified.


The Macht Schnell EDC Emulation Module is possible of the following features:
Note: The Macht Schnell EDC Emulation Module will disable the EDC monitoring system supplied by BMW. Once disabled the behavior of the car will change and the driver will need to adjust his/her skill and technique. For this reason, this module is not intended for street vehicles and its use may result in injury or even death if proper conditions and procedures are not followed.
Will not work on vehicles equiped with BMW's Dynamic Drive system.
This item fits the following BMWs:
2008-2011 E90 BMW M3 Sedan
2008-2013 E92 BMW M3 Coupe
2008-2013 E93 BMW M3 Convertible
2006-2010 E60 BMW M5
2006-2011 E63 BMW M6
2007-2013 E70 BMW X5 3.0si X5 4.8i X5 xDrive30i X5 xDrive35d X5 xDrive35i X5 xDrive48i
2008+ E71 BMW X6 xDrive35i X6 xDrive50i






The H&R Coil Over kit takes the traditional shock/spring package one step further. H&R combines their progressive-rate springs with specially valved shocks and adds height adjusters that let you set the ride height to your own personal tastes. These coil overs are designed for street use with progressive rate springs that start out soft and stiffen as they are compressed. This helps to keep the ride compliant while still giving better handling and balance.
H&R designs each suspension to work as a coil over. This means that the correct amount of travel has been built into each shock. And the shocks are valved specifically for the spring rates to give a tight and controlled ride without being harsh or ultra-stiff. Each H&R coil over is TUV tested and approved and meets ISO quality standards. These are used with the stock strut and shock mounts for a quick and easy install. This suspension is a direct replacement for cars without EDC. For an EDC-equipped model you will need an EDC emulator and non-EDC mounts.
SPECIAL PRICING FOR A VERY LIMITED TIME!
FREE GROUND SHIPPING
Height adjustment range:
F: -1.0-1.6"
R: -.3-1.3"
SPECIAL PRICING FOR A VERY LIMITED TIME!
This coilover suspension kit fits the following BMWs:
2008-2012 E93 M3 convertible

