One of the tricks for getting your BMW to handle better is to add negative camber to the front wheels. This will put more of the tire's width in contact with the ground during cornering. With more rubber there is more grip. BMWs typically have less camber in the front to create understeer. But if you're running a stock setup on the track or autocross you are giving up speed and time as the front tires run out of grip sooner than they should. Here at Turner Motorsport, we offer a variety of camber plates, including our own in-house engineered version, so that you can pick out a solution that works best for your BMW.
Location: Front Type: Track, Stage 3 Bearing: PTFE-lined pillow-ball, no bushing
KMAC Stage 3 camber/caster plates are designed for track or race-only situations where comfort and noise are not the primary concerns. The Stage 3 camber plates use a pillowball bearing, solidly mounted within the camber plate for direct alignment of the strut shaft and no excess play or deflection. Stage 3 are designed to increase negative camber with their patented 'floating' adjustment that changes camber and caster together. This design allows maximum range of adjustment since no other hardware interferes with the adjustments. Fitment is limited to race-only small diameter coil-over springs (not stock-type). Bearing inserts and adapters included. Detailed instructions included.
Note: suspensions vary from manufacturer to manufacturer. Turner Motorsport cannot be responsible for fitment issues caused by non-stock or specialized coil-over suspensions. As with any race-derived component, additonal fabrication may be required.
This item fits the following BMWs: 1997-2003 E39 BMW 525i 528i 530i 540i (for cars with EDC) 1999-2003 E39 BMW M5 1995-2001 E38 BMW 740i 740il 750il (for cars with EDC) 2004-2010 E60 BMW M5 2004-2011 E63 BMW M6
Show More Show Less