Please ensure your correct model is selected
This product was last offered at the strikethrough price on
05-05-2026
This product was last offered at the strikethrough price on
05-05-2026
WHEEL STORAGE RACK:
Now you can stack your extra wheels without the danger of scratches and scuffs. This wheel storage rack keeps your wheels spaced apart, and being on locking casters, allows you to easily move the whole set anywhere in your garage or shop at one time. Sturdy steel construction and a wide base means this wheel rack won't tip over. Holds up to 275 lbs - enough for most any wheel & tire set.
Fits up to 8½" wide wheels, depending on offset
TIRE STACK COVER:
This tire stack by Schwaben is the solution to keeping your tires and wheels clean while in storage.
WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, and/or reproductive harm. See above warning label as well as http://www.p65warnings.ca.gov for further information on Proposition 65 warnings.
This product was last offered at the strikethrough price on
06-13-2026
This product was last offered at the strikethrough price on
06-13-2026
This product was last offered at the strikethrough price on
02-18-2026
For all of us who grew up with lug bolt-equipped cars, it can be a pain to re-install wheels. With no studs to guide the wheel onto the hub, you're left searching for that perfect alignment all while blindly trying to find a lug bolt to thread into place. Not a pleasant experience.
Future Classic's wheel hangers allow you to thread two guide pins into the hub to make re-installing wheels a breeze. We have created a guide pin for each of the most popular thread pitches, each size features a ridged body to prevent the wheel from falling off the hub once it is seated. A perfect accessory set for every tool kit.
Product Details:
Makes fitting lug bolt-equipped wheels much easier M14x1.5 thread pitch Aluminum construction Threaded end with ridged body to prevent wheel travel Sold as a set of two
The E-Z Chamfer deburring tool, constructed from High Speed Steel (HSS), is designed to eliminate burrs and ridges from threaded rods, bolts, pipes, and bar stock. Its size range of 0.7” – 1.5” (18-38mm) allows efficient removal of threads and burrs, creating a smooth chamfer for effortless nut and die insertion. Compatible with mild, hard, very hard, stainless, and super hard steels, it delivers optimal results when used with slow drill speeds and moderate pressure on most materials. To extend the tool's lifespan, it's advisable to operate at speeds below 800RPM and refrain from using impact drivers. Typically, only 1-3 threads need chamfering for a clean start.
Additionally, E-Z Chamfer sizes between 18-24mm require a speed of 600RPM, those ranging from 23-29mm perform optimally at 400RPM, and sizes from 30-38mm are best suited for a speed of 300RPM.
