Turner Motorsport has everything you need to upgrade your BMW through our stages of performance or to keep your car in peak condition with our range of the latest in proven OEM cooling parts. Upgrade your cooling system and engine performance with the selections below to give your BMW a performance and reliability advantage.
Over time, your engine timing components begin to wear out. Tensioners weaken, chains can stretch, and timing chain guides can wear down. All of these lead to the possibility of the timing chain jumping teeth on the sprockets, causing your timing to shift. This could result in rough idle and reduced engine power, or even complete engine failure. Prevent damage to your engine with new timing components, such as this IWIS timing chain tensioner. Note, we recommend replacing timing components every 100K miles, or sooner, depending on the condition of the timing components.
Show More Show Less
The camshaft position sensor communicates the position of the camshaft to the computer. This helps the computer to calculate proper spark and fuel control. If you're struggling with CELs, hard starts or no starts, stalling, and/or a rough idle, you may need to replace the cam position sensor.
Show More Show Less
Ignition coils are key to the efficiency and performance of your BMW. With a faulty coil the spark plug is not burning the air/fuel mixture properly and that can lead to problems anywhere in the engine and exhaust (including catalytic converters and O2 sensors). Problems with one or more coils will cause a fault code, but not always a check engine light. A misfire code may be related to an ignition coil, but could be from other things as well. ometimes, a visual inspection of a coil and coil boot will give an indication of a failure. You can also move coils around to different cylinder banks to see if the misfire code follows a suspect coil. We suggest always having one or two coils on hand to keep as spares.
Show More Show Less
The crankshaft position sensor transmits the crankshaft's position to the computer. This helps the computer to calculate proper spark and fuel control. If you're struggling with CELs, hard starts or no starts, stalling, and/or a rough idle, you may need to replace the crank position sensor.
Show More Show Less