Transmission and Differential Tools for BMW 5 Series F10 (2011-2016)

Clear BMW chassis

Please ensure your correct model is selected

Servicing your transmission, differential, or mounts can be an involved, but necessary, process. Confidently approach your next service with all the tools you would need to complete the job successfully with our recommended service tools and equipment. You can find all transmission and differential service equipment for your next job on this page.
Sort By:

Enthusiast Bundles - Corporate Logo
T#:34919063
Part#: 006192ECS01A2KT
Ships on Dec 10, 2025
Sale - Save 25% $ 118.99
$ 88.97 USD
Free Shipping on orders $49 and up
Sale - Save 25% $ 118.99
$ 88.97 USD
Free Shipping on orders $49 and up
Schwaben by Race Ramps - Corporate Logo
T#:366904
Part#: 006160SCH01AKT
In Stock
$ 677.99 USD
$ 677.99 USD

These ramps never scoot, slip or slide while rolling onto the ramps.All that said means these ramps are easy to drive up on and very safe. Our Schwaben ramps will never scratch or blemish your floors.

Having ramps to use offers more than just convenience, it offers safety. Laying under a car working is much easier to do knowing the car is resting the wheels on a firm surface.

Please refer to chart below to see if these 67" Schwaben ramps are right for you vehicle.

1. Take a yardstick, and wedge it under the front edge of front tire.

2. Raise it up until it hits the underside of your car( the spoiler)

3. Measure from the tip of the yardstick to the ground, vertically.

 67 " long,14" wide, 10" lift height, at 15 lbs each and a low 10.8 degree incline.

If your measurement is 7.25" or greater, you can clear these ramps with no problem. 

These extensions will lower your approach angle to 6.6 degrees. Once you get the car into place, you can remove the extensions for more working room under the vehicle. One set holds up to 3000 lbs.

For increased safety, use wheel chocks with all Schwaben Ramp products.

Show More Show Less
Enthusiast Bundles - Corporate Logo
T#:25739361
Part#: 029121SCH01KT
Ships on Aug 11, 2025
Sale - Save 16% $ 488.99
$ 408.73 USD
Sale - Save 16% $ 488.99
$ 408.73 USD

Elevate your lifting experience with the Schwaben Long Low Profile - High Lift Floor Jack. Certified for excellence and designed with a keen understanding of European car enthusiasts' needs, this jack is a testament to precision, durability, and performance. Don't compromise on quality—choose the Schwaben advantage for all your lifting endeavors.

Designed with precision, crafted for performance, and backed by our lifetime replacement program, the Schwaben Long Low Profile - High Lift Floor Jack is a must-have tool for every European car aficionado. This jack is engineered to cater to the unique needs of low ground clearance vehicles, ensuring that your prized possessions are lifted with care and precision.

Key Features:

  • One Pump Reach: With its innovative one-pump feature, this floor jack effortlessly reaches contact on most cars, streamlining your lifting process.
  • Low Profile Advantage: Boasting a mere 2-3/4" low height and a deep-reach lift arm, this jack is tailored for those sports cars and luxury vehicles that ride close to the ground.
  • Hydraulic System Protection: The dual pump pistons are expertly shielded to thwart contaminants from compromising the hydraulic system's integrity.
  • Built for Durability: Crafted with heavy gauge construction and fortified with rolled edges, this floor jack guarantees unwavering strength and longevity.
  • Precise Control: The U-Joint release mechanism offers meticulous control over load descent at any handle position, ensuring the safety of both you and your vehicle.
  • Maneuverability Redefined: Upgraded casters allow seamless maneuverability and effortless positioning of the jack, empowering you to find that perfect lifting spot.
  • Safety First: The internal by-pass valve prevents over-pumping, shielding the hydraulic system from stress-induced issues.
  • Vehicle Protection: A full cover rubber saddle pad and a protective foam cover on the handle are in place to prevent any unintended damage during the lifting process.
  • Impressive Capacity: With a remarkable 4000 lb. capacity, this jack is ready to tackle a range of European vehicles.
  • LIFETIME REPLACEMENT: Like almost all Schwaben products, this jack is backed by our lifetime replacement program in case anything goes wrong!

Specifications:

  • Min Height: 2-3/4"
  • Max Height: 24"
  • Handle Length: 49-1/4"
  • Jack Body Length: 35"
  • Length from Pivot Point to Center of Jack Pad: 22"
  • Front Casters: 2-1/2" diameter x 2" width
  • Saddle Diameter: 4" with full saddle pad
  • Weight Capacity: 4000 lbs.
  • ANSI / ASME PALD 2009 Certified

Also included are the Schwaben Aluminum 3-Ton Jack Stands. These ultra-light Schwaben jack stands only weigh 4.7 lbs each. Fit and finish on these stands show how much pride in workmanship goes into our stands. These stands feature all-aluminum construction with heavy-duty flanged bases to safely stabilize loads. Features 6 locking positions for a secure load in multiple heights. The load pin is extra heavy duty at .584 in. diameter and features a posi lock ball to ensure the pin stays in place.  

  • Min. Height is 10.6".
  • Max Height is 15.4".
  • Large 7" diameter base.
  • Outer support tube is 2-1/8" in diameter.


For replacement parts, please call us and ask for:

  • ES#4430428 - Replacement Screw Set
  • ES#4430429 - Replacement Front Wheel
  • ES#4430430 - Replacement Caster Wheel

WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, and/or reproductive harm. See above warning label as well as http://www.p65warnings.ca.gov for further information on Proposition 65 warnings.

Show More Show Less

Schwaben by Race Ramps - Corporate Logo
T#:387954
Part#: 006143SCH01AKT
Ships Aug 19, 2025
$ 562.99 USD
$ 562.99 USD