BMW Performance Chips & Software for BMW F85 X5 M S63 4.4L

BMS Pedal Tuner - N52, N54, N55

affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms

T#:586269

Part#: BMSPBT

In Stock

$ 199.00 USD

Add to Wish List

Qty

$ 199.00 USD

Add to Wish List

The BMS Pedal Tuner is a BMW Performance Chip with a pre-programmed internal chip that intercepts the stock signals from your BMW's electronic control unit (ECU) and changes them to achieve better performance by adjusting the air-fuel ratio and spark timing. Made specifically for the BMW inline six-cylinder motors. The PBX also has an adjustable throttle feature that can be combined with the Performance chip feature by selecting a setting or "map". The BMS Pedal Tuner contains both a performance chip which gives you an extra 8-10 Horsepower at the wheels and an adjustable throttle boost feature that makes the gas pedal send a boosted throttle signal in increments of 30%, 60%, and 100% over the stock BMW signal. Depending on what setting/ "map" you select you can create a perfect blend of throttle response. The BMS Pedal Tuner will make your vehicle more responsive, spirited and fun to drive. It will make your vehicle faster by increasing the horsepower and torque. It works well with other modifications like intakes and exhausts, but can also be used alone. It will remove the "dead space" when you push on the non-responsive stock BMW accelerator. It changes the way the car drives and feels. You can turn it on and off from the comfort of your driver's seat to feel the difference. The BMS Pedal Tuner is a clear choice. Features: Throttle Re-mapping for Better Response / Reaction Removes "dead area" delay in gas pedal 7 Different Maps / Settings for more enjoyable driving Can be set and turned on and off from inside the car Invisible to dealers equipment Made in USA

Show More Show Less

JB4 Bluetooth Wireless Connect Kit - Pinned Power Wire - F-Chassis & ...

affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms

T#:598298

Part#: JB4-SPWCK-F

In Stock

$ 159.00 USD

Add to Wish List

Qty

$ 159.00 USD

Add to Wish List

The JB4 Connect Kit (Rev 3.7) allows your Bluetooth 4.0 compatible iOS and Android devices to connect wirelessly to your JB4. View critical engine data in real time, datalog, read codes, change maps, update settings, update firmware, and more, all from the palm of your hand! The REV3 mounts next to the JB4 in the engine bay eliminating the need to run a BMS DATA cable inside the cabin. It's compatible with all JB4 products. Just plug it in to the JB4 where your BMS DATA cable connects, purchase the JB4 Mobile app, and you're off and running. Please note the JB4 Mobile app is available for iPhone®, iOS®, or Android and sold separately via the Apple® or Android® app store on your phone. The wireless adapter is not compatible with the JB4 windows interface. See our other listings for the "BMS DATA cable" for laptop use.

Show More Show Less

JB4 Bluetooth Wireless Connect Kit - Separate Power Wire - E-Chassis ...

affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms
For use with older E chassis BMW JB4 systems with the square plastic case.

T#:403194

Part#: JB4-BT

In Stock

$ 149.00

This product was last offered at the strikethrough price on
05-13-2026

$ 99.00 USD

Add to Wish List

Qty

$ 99.00 USD

Add to Wish List

The JB4 Connect Kit (Rev 3.7) allows your Bluetooth 4.0 compatible iOS and Android devices to connect wirelessly to your JB4. View critical engine data in real-time, datalog, read codes, change maps, update settings, update firmware, and more, all from the palm of your hand! The REV3 mounts next to the JB4 in the engine bay eliminating the need to run a BMS DATA cable inside the cabin. It's compatible with all JB4 products. Just plug it into the JB4 where your BMS DATA cable connects, attach the power and ground wire to the JB4 harness using the included connectors, purchase the JB4 Mobile app, and you're off and running. Please note the JB4 Mobile app is available for iPhone®, iOS, or Android® and sold separately via the Apple® or Android® app store on your phone. This adapter is not compatible with the JB4 windows interface.

Show More Show Less

Throttle Booster

Call In Or Chat For Best Price! affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms
Call In, Chat, Or Email, For Best Price! Limited Time Only!

T#:11693563

Part#: D440-1700

In Stock

11% off MSRP $ 325.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 288.99 USD

Add to Wish List

Qty

11% off MSRP

$ 325.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 288.99 USD

Add to Wish List

BMS JB4 Port Injection Controller - F/G Chassis

affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms

T#:21012590

Part#: F-G-PORTINJCONMO

No longer available

The Burger Motorsports JB4 Port Injection Controller attaches to the JB4 allowing it to directly control both traditional port injection kits and WMI port injection kits. The JB4 port injection controller is a fully integrated solution allowing enhanced port injection mapping and safety. For example the JB4 port injection controller: 1) Uses low fuel pressure in conjunction with boost pressure to evaluate injection pressure and adjust PI IPW dynamically as required to maintain consistent flow volume. This becomes particularly important in applications that are at the edge of their low fuel pressure supply. As low pressure drops or oscillates port injection IPW must be dynamically adjusted to avoid run lean conditions. 2) Monitors pedal input, clutch input, gear, throttle position, etc, allowing more advanced mapping and instant cut of PI when letting off the gas or when traction control kicks in to avoid backfires. 3) Monitors AFR in both banks and can cut PI flow in the event a misfire event is detected preventing a potentially lean condition. 4) Monitors current through the injectors and sends a signal back to the JB4 altering it of various problems including a clogged or disconnected injector, blown electrical fuse, loose ground, etc. 5) Monitors fuel trims in each bank and failsafe's in the event of a mismatch of more than 15% indicating a potential boost single cylinder boost leak or injector flow issue. 6) Allows easy user adjustment of overall fuel volume using linear "Fuel Bias 0-100" values by RPM, greatly reducing the typical mapping complications when making manual tuning changes. 7) Integrates into the JB4 multi-map system which produces on-the-fly PI mapping changes when you change maps when boost is reduced in lower gears, or during anti-lag engagement. 8) When equipped with a JB4 integrated flex fuel sensor or JB4 virtual flex fuel sensor can automatically adjust port injection volume based on the E85 mixture allowing for easy mixture changes. 9) Enhanced mapping logic such as tip in supplement to boost port injection during sudden transitions like spool up or gear changes where the high-pressure pump tends to have problems keeping up. 10) Does not require a separate interface and cable for mapping and tuning port injection. It's all done right through the JB4 interface and logs greatly simplifying the process. 11) Includes an extra output to run your second fuel pump OR WMI PUMP (for port injection meth), eliminating the need for an extra Hobbs switch.

Show More Show Less

DINANTRONICS X Performance Tuner - S63TU/S63TU2

Call In Or Chat For Best Price! affirm Starting At 0% APR - Subject To Eligibility. See Lending Terms
Works with 2012-2019 model years

T#:16142439

Part#: D440-0133

Back Ordered

11% off MSRP $ 787.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 699.99 USD

Add to Wish List

Qty

11% off MSRP

$ 787.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 699.99 USD

Add to Wish List

Max gains of up to +50 HP and +47 lb-ft TRQ (Crank); +46 HP and +46 lb-ft TRQ (Wheel) The DINANTRONICS X is the newest installment of the highly successful Dinan foray into inline tuning modules. Like its predecessors, it is a highly engineered piece of computer hardware and software that enhances engine performance to levels the stock programming is not allowed to venture. It does this without affecting long-term reliability or the functionality of on-board diagnostic systems when run under recommended operating variables. Unlike its predecessor, however, the DINANTRONICS X is Bluetooth smart and offers convenient access to the adjustment of power levels directly from the palm of your hand. A further advancement beyond its entry-level little brother, the DINANTRONICS SPORT, X connects to additional inputs and has a more refined tuning strategy that yields more power as a result. For those that do not wish to (or can't) alter their stock ECU with a more robust engine flash the DINANTRONICS X is a perfect alternative to satiate the craving for "more". Whichever level of engine tuning is ultimately chosen you can be sure to be pleased with the result. The Dinan Difference is possible by employing a full staff of talented engineers that are well-rounded in many facets of automotive engineering and backed by a wealth of hands-on knowledge. Stemming from diverse backgrounds not only on racing teams but on standard factory production line vehicles, we have seen it all. Manipulating these signals/maps with an adept hand, all the while keeping an engine running at its best and with the most reliable power, is what Dinan is all about. The DINANTRONICS X offers an array of different power levels (maps). These maps range from a bypass/stock setting at map 0 to a maximum power setting at map 7. The unit is shipped in map 5. This middle ground setting should be acceptable for all vehicle/engine configurations. However, you can adjust up or down as you see fit for your needs and/or modifications. Please note however that for each map level we highly recommend the minimum fuel octane rating to run listed below. If you sense any unusual or unexpected behavior immediately turn down the map to a lower setting that did not exhibit the condition. MAP(S) - MINIMUM OCTANE 1-3 - 91 4-5 - 91/93 6 - 93 7 - 93+ WARRANTY NOTE: DINANTRONICS X does not carry the factory matching warranty that Dinan is known for. DINANTRONICS X's warranty is a 1-year, product only warranty, that does not cover consequential damages or labor reimbursement.

Show More Show Less

Project Cars

SELECT YOUR BMW

BMW Performance Chips & Software for BMW F85 X5 M S63 4.4L

Sub-Categories

BMS Pedal Tuner - N52, N54, N55

JB4 Bluetooth Wireless Connect Kit - Pinned Power Wire - F-Chassis & ...

JB4 Bluetooth Wireless Connect Kit - Separate Power Wire - E-Chassis ...

Throttle Booster

BMS JB4 Port Injection Controller - F/G Chassis

DINANTRONICS X Performance Tuner - S63TU/S63TU2

Select Vehicle

Purpose

Category

Brand

Price

Shipping

Narrow Results