Packaged by Turner Clutch Installation Kit

When installing a new clutch, it is important to replace old hardware and common wear items. This ensures both a smooth and reliable installation. This also allows you to perform maintenance while everything is apart as opposed to a needing to make future repairs when everything is back together.

Included in this kit:

• Flywheel bolts
• Bolts bell housing, one time use!
• All hardware to re-mount the driveshaft
• Pilot Bearing
• Clutch fork pivot pin
• Clutch alignment tool
• Metal Guibo
• Center support bearing 

Fits the following BMWs:
E9X BMW 335i/is N54 N55

When installing a new clutch, it is important to replace old hardware and common wear items. This ensures both a smooth and reliable installation. This also allows you to perform maintenance while everything is apart as opposed to a needing to make future repairs when everything is back together.

Included in this kit:

• M3 upgraded transmission mounts with all mounting hardware
• Pilot bearing
• Giubo/universal flex disc with mounting hardware
• Driveshaft center mount
• Necessary gaskets and hardware for re-mounting the exhaust system
• Clutch fork lever and pivot pin
• All bellhousing bolts, and dowels
• Pressure plate screws, flywheel bolts
• Loctite 271 high strength thread locker for flywheel bolts

Fits the following BMWs:
E46 BMW  M54 325i/Ci, 330i/Ci (up to 03/2003)

When installing a new clutch, it is important to replace old hardware and common wear items. This ensures both a smooth and reliable installation. This also allows you to perform maintenance while everything is apart as opposed to a needing to make future repairs when everything is back together.

Included in this kit:

• Genuine BMW hardware with the exception of flywheel bolts which are an original equipment supplier
• 2 Genuine BMW E46 M3 transmission mounts
• Genuine BMW clutch fork pivot pin
• Original Equipment Supplier driveshaft washer gasket
• MTC universal flex disc (AKA Guibo) with hardware
• MTC driveshaft center carrier
• FAG pilot bearing
• Victor Reinz rear main seal

Fits the following BMWs:
E36 BMW M3 S50/52

When installing a new clutch, it is important to replace old hardware and common wear items. This ensures both a smooth and reliable installation. This also allows you to perform maintenance while everything is apart as opposed to a needing to make future repairs when everything is back together.

Included in this kit:

• All needed hardware
• Transmission mounts
• Clutch fork pivot pin
• Universal flex disc (AKA Guibo) with hardware
• Driveshaft center carrier
• Pilot bearing
• Exhaust Pipe Gaskets

Fits the following BMWs:
E39 BMW M5 S62