Turner Motorsport has everything you need to upgrade your BMW through our stages of performance or to keep your car in peak condition with our range of the latest in proven OEM cooling parts. Upgrade your cooling system and engine performance with the selections below to give your BMW a performance and reliability advantage.
This Boost Leak Tester kit mounts inside both of the flexible intake hoses that lead to your turbo's compressor inlet flanges. You will need to remove the air box (or your aftermarket air filters) to expose the 2 intake pipes. Install the testers in each pipe and pressurize the system using the tire schrader with your tire inflation tool. The kit comes with the necessary caps to block the diverter valve return flanges on the intake pipes, also a cap to block the breather line at the bakc of the valve cover. Once the kit is installed, use compressed air to charge the system and you will see that both gauges read the compressor pressure you are filling with. You'll be able to test the turbo to the motor checking all leak points in between, including intercooler, clamped connections, intake manifold, divertor valves and the many random potential leak points. Note: Testing at the intake pipe, you may hear noise coming from the o-ring (at ~12 psi test pressure) that seals the intake pipe to the turbo inlet from debris. This is not a boost leak, these are not meant to see boost and not intended to be perfectly sealed, however hearing this hissing may be mis-diagnosed as a leak. In this case reduce the pressure. If no obvious leaks are heard in any other location, the test is complete and there are no significant leaks The gauge on the boost leak tester allows the user to: apply a safe amount of pressure to prevent injury or damage to the charge pipes or engine read how fast the system holds and bleeds air after removing the air source give a good comparison of compressor outlet air Vs. boost test air while pressurizing. The smaller the difference the lesser the air loss in the system Design Features: Plastic End Caps with 1/8" NPT threaded gauge port & fitting port Boost Gauges with 30 PSI / 1Bar Boost Gauge Universal Tire Schrader Valve (can be removed and tapped for 1/4" NPT thread fitting if desired) (2) Stainless Steel T-Bolt Clamps with Teflon lock-nut (3) Vinyl Caps for diverter valve return and valve cover breather
Show More Show Less
The Precision Raceworks E9x / E8x LOW PRESSURE BUCKETED FUEL PUMPS are designed for customers looking to run all blends of E85 and flow up to 3.9 liters per minute. The included Genuine Walbro 535 (F90000295) fuel pump is capable of flowing up to 350% more fuel than the factory fuel pump and is 100% E85 compliant. Precision Raceworks' Stage 2.5 V2 bucketed fuel pump comes with a single Walbro 535 (F90000295) fuel pump. This pump can support up to 650whp (Rated for 550whp on 100% E85) and is ready to grow with you as your needs demand. Unlike other manufacturers, Precision Raceworks is the only company featuring a bucketed kit with a modular design. This means you can purchase their stage 3 pump module or Stage 3.5 module and upgrade the pump as your needs change. If you are looking for a 100% assembled drop-in-ready solution, this is the choice for you! **Some European Spec vehicles may require the re-use of the top hat due to differences in emissions requirements. This is a true plug-and-play solution that anyone can install in their home garage and start taking advantage of the benefits right away. Features & Specifications: Lock Ring Tool Included Pump flow 72psi (5bar): 1.0 GPM / 3.9 LPM Pump Weight: 3.98 lbs Horsepower Supported Pump Gas: 650 Horsepower Supported 100% E85: 550 Aftermarket EKP Required: No
Show More Show Less
