Click here for installation instructions.
Select Vehicle
BMW
Mini
Purpose
Category
-
Rear Control Arms
Create an account to be able to build Wish Lists.
Please ensure your correct model is selected
This product was last offered at the strikethrough price on
06-13-2026
This product was last offered at the strikethrough price on
06-13-2026
TMS rear subframe bearings are designed to limit rear control arm movement relative to the subframe. The stock BMW subframe bushings are made out of rubber, which allows variance in suspension position due to deformation and compression. A race car needs to have all suspension points remain in place for proper setup. By using high grade aircraft aluminum alloy and high performance race bearings, the TMS bushing replacements are both lightweight and strong. The casing is designed so that if maximum motion occurs, the load will be evenly distributed throughout the casing. Our flanges are designed to spread the load on the subframe and limit movement. The bearing we use is an extra wide race bearing to distribute the load over a broader area. Each piece is anodized or nickel plated to withstand corrosion. These bushings are a perfect compliment to the TMS lower camber arms.
This product was last offered at the strikethrough price on
06-13-2026
This product was last offered at the strikethrough price on
06-13-2026
The E36/E46 rear trailing arm bushings (RTABs) wear out faster than any other bushing on the car. Worn RTAB will cause excessive toe alignment change and give a 'loose' or 'floaty' feeling in the rear handling. One of the reasons for this is that they over-extend during motion, stretching and twisting the rubber in all directions. These shims sit on either side of the bushing and limit the amount of extension from the bushing. Not only will you get more life from your RTAB but these will help stiffen the bushing during cornering. But during normal driving you will still have all of the comfort of the stock rubber bushings. These part about these bushings is how easy they are to install - simply slide them in place during your bushing install. They can be added to pre-installed bushings too by dropping the trailing arm and removing the cage around the bushing.
Works with stock rubber bushings only (not urethane or Delrin).
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.