E46 Strut Tower Reinforcement Plates - priced each

Like the E36 before it, the front strut towers on the E46 are notoriously weak. Under normal driving conditions with a stock, fresh suspension it is unlikely that you will ever have a problem. But with an upgraded street or race suspension with firm springs much of the energy from pounding the road is transmitted to the thin sheet metal in the strut tower. This pounding will cause the tower to deform or even crack. Look for 'mushrooming' or deformity around the holes for the three mounting studs at the top of the strut tower. The sheetmetal around the holes should really be flat and square. Poor shocks or stiff suspensions will actually cause this sheetmetal to pop up.

These factory BMW reinforcement plates will help disperse the energy and save you from costly repairs in the future. A strut brace also helps to prevent this but these plates are designed to reinforce the strut tower from the bottom. The install over your strut mount or camber plate and simply add thickness (strength) to the strut tower. They can be sandwiched in place and do not require welding.

This item fits the following BMWs:
1999-2005 E46 BMW 323i 323ci 325i 325ci 325xi 328i 328ci 330i 330ci 330xi
2001-2006 E46 BMW M3*
* - The stock M3 upper strut mount already does a good job of dispersing the loads of the suspension. These reinforcement plates will fit a stock mount for added strength but need to be trimmed to fit inside the strut tower. The are very strongly recommended for all M3s with coil over suspensions because aftermarket coil overs typically have a smaller surface area for their strut mounts.