High-output top-mount single-turbo BMW builds operate at significantly higher manifold pressures and thermal loads than factory twin-turbo configurations. When a silicone coupler slips, a V-band seal degrades, or a blow-off valve flange leaks under boost, the turbocharger must spin at a much higher shaft speed to meet target manifold pressure. Operating beyond the compressor map's efficiency island spikes intake air temperatures, induces erratic spool, and accelerates thrust bearing wear, risking catastrophic compressor wheel-to-housing contact.
This 4" Boost Leak Tester Kit attaches directly to your single turbo's compressor inlet flange, allowing you to statically pressurize the entire cold-side charge piping, intercooler, and intake manifold with regulated shop air. By monitoring the included 30 PSI / 2 Bar gauge once the air source is disconnected, you can quantify system bleed-down rates (typically ~1 PSI per second on a healthy setup) and isolate pinpoint leaks before hitting the dyno or the track.
Application: Top-mount single turbocharger conversions utilizing a 4.0" OD compressor inlet. (Common among many turbos, BorgWarner, Garrett, Precision running anti-surge housings)
End Cap Construction: CNC-machined 6061 billet aluminum cap machined with 1/8" NPT (gauge) and 1/4" NPT (air inlet) ports.
Pressure Monitoring: Custom stainless steel 30 PSI / 2 Bar boost gauge for accurate low-to-high boost verification and leak-down rate diagnostics.
Air Supply Fittings: Includes a 1/4" NPT male compressor fitting and a universal Schrader valve adapter for compatibility with standard tire chucks or regulated air lines.
Coupling & Clamping: Heavy-duty 3" to 4" reinforced silicone coupler secured by dual stainless steel T-bolt clamps with nylon/Teflon-insert lock nuts to prevent blow-off under static pressure.
Prop 65 Warning
Product Q&A
Lifetime Replacement
This product is not eligible for Lifetime Replacement
Fits These Cars
MAKE
MODEL
SUBMODEL
ENGINE
Special Fitment Notes
BMW
All
All
B48 2.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
B57 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
B58 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
N20 2.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
N54 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
N55 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
S55 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
BMW
All
All
S58 3.0L
For BMWs with aftermarket big turbo setups only - will not fit a stock turbo
*The above product applications have been written by Turner Motorsport. All
warranties, product application, fitment, and performance are the responsibility of Turner Motorsport.
For additional information see the terms of use.