This Febi Bilstein 5-piece fastener set offers genuine OEM-level durability and precision tolerance to ensure your vehicle stays tightly bolted together.
Frequently damaged during removal, the brake rotor set screw helps hold your rotor in place for easier installation of both the rotor and wheel. On vehicles with wheel bolts instead of studs, aligning the rotor and wheel holes can be tricky or even impossible without it. This replacement screw keeps everything aligned, simplifying the process. Apply a bit of anti-seize during installation to make future removal effortless.
Show More Show Less
Looking to service your automatic transmission? Don't forget the new clean fluid for use to refill and keep your transmission shifting smooth. Check capacities prior to ordering to be sure you have enough to do your transmission service. See your owner's manual for service intervals. High protection against freezing, corrosion, and cavitation Excellent lubricating properties, high ageing resistance, and high wetting and adhesion properties Prevention of deposits and foam formation Compliance with the requirements of vehicle manufacturers
Show More Show Less
Includes integrated ball joint and nut. Does not include control arm bushing. The integrated ball joint within this control arm is prone to failure, resulting in clunks over bumps or while turning. Control arm bushings (sold separately and must be pressed in) are also prone to failure on E39 vehicles, resulting in a wandering front end, and vibrations under braking.
Show More Show Less
The Febi Bilstein Rear Eccentric Bolt Repair Kit delivers OEM-grade hardware engineered to secure your rear suspension arm alignment under high-stress conditions.
These replacements from Febi are the perfect solution for worn mounts/bearings. Because they are factory OE parts, they fit perfectly in the mounting location and are the proper length and have the correct inside diameter for your struts. A small addition to any front suspension overhaul that can make a huge difference in overall ride quality. Priced each, but should always be replaced in pairs. To get the most out of your new suspension setup, it's recommended that you replace all parts that are known to fail. Not only will this make your new setup more effective, it will provide a better ride, proper tire position, and make all of your parts last longer. One often overlooked piece is the upper strut bearing and mount. This is the top mount for your struts and provides a solid platform for your front suspension. If worn, the bearings within this mount make noise, there is slop from worn rubber, and it can shorten the life of your shocks.
Show More Show Less