BMW Intake Parts for BMW Z Series E85/6 (2003-2008)

Flexible silicone smooths the intake tract while allowing for a range of performance intakes fitments. The ultimate in durability!

In most vehicle applications, the rubber intake elbow found in the intake system is not designed for performance or modification. They were designed to get the job done but when you add a performance filter, intake or tune, the stock elbow will start to show it weakness. The stock rubber elbows disrupt air flow as it passes over the accordion sections causing unwanted turbulence and negating the effects of intake modifications.

With high quality 4 ply construction, the Turner intake boot is strong but flexible, ensuring a secure fit on an OEM or aftermarket intake system. A smooth interior ensures unimpeded airflow, while a smooth, unassuming exterior adds to any engine bay.

Benefits:

Improved throttle response,
Increase induction sound
Increased power output - and power output, Best when paired with an ECS drop-in air filter.(ES4461001 or ES4460965)

A bad DISA valve can cause a variety of issues, from a loud racket in the engine bay, hesitation at low rpm and a rough idle with lean codes.

If the valve is making a loud noise, we recommend replacing it as soon as possible. It is possible for the pin holding the flap to be sucked into the motor causing serious damage.

Very easy to replace, just need to undo the 4 bolts holding it to the intake manifold.

Includes new mounting hardware

Ensure your vehicle maintains optimal fuel efficiency and performance by swiftly replacing the Mass Airflow Sensor (MAF). This crucial component regulates fuel delivery through injectors based on incoming air volume. A faulty MAF can significantly impact gas mileage and overall performance.

Gradual MAF failure often results in reduced fuel efficiency and performance degradation. Complete failure may cause stuttering and stalling, forcing the vehicle into a limp mode. A simple diagnostic test involves unplugging the MAF connector before starting the car; improved idling indicates a faulty MAF requiring replacement.

Failure to replace the MAF leads to excessive fuel consumption and inefficient burning, adversely affecting fuel economy. Opt for a Genuine BMW MAF replacement to ensure stock-quality performance and enhance vehicle efficiency.

Due to weak plastic construction, the factory plastic crankcase ventilation breather hose is known to fail. After years of exposure to piping-hot engine bay temperatures and chemical-laden oil vapors, the corrugated plastic tubing can crack, crumble, or fail altogether.

We set out to bulletproof your N52 CCV system with a durable silicone breather hose, designed to provide a comprehensive upgrade and permanent replacement for the factory plastic hose. By replacing the flimsy, heat-hardened OEM plastic hose with a four-ply fluorosilicone hose, you'll experience peace of mind knowing your N52 is free from the inevitable return of oil leaks, vacuum leaks, and drivability concerns that would have been.

This breather hose is found at the front of the engine, and is used to connect the oil separator to the valve cover. It replaces OEM part number 11157522931.

Features:

Silicone construction ensures a durable replacement that is sure to outlast OE plastic
Designed as a direct replacement for the factory breather hose
Retains heating function and OE electrical connector
Design:

Four-ply wire-reinforced fluorosilicone hose is designed to resist degradation due to exposure to oil vapors
O-rings are pre-installed in OE connectors for a lasting seal
Includes pre-installed zinc-coated hose clamps for durability and corrosion resistance
Product Development:

Our Silicone CCV Hose Upgrade was designed, engineered, tested, and quality inspected by our Research and Development team in our Wadsworth, Ohio, facility. We strive for the highest level of precision and quality through leading-edge product development technology, including FARO laser scanning for reverse engineering and quality inspection, SolidWorks 3D CAD modelling, rapid prototyping utilizing our in-house 3D printer, and rigorous long-term product testing.