BMW Electrical Sensors, Switches, & Relays for BMW 6 Series F06 (2013+)

Clear BMW chassis

Electrical gremlins can be very frustrating. Luckily your BMW's electrical system is better than most, even if it's 25 years old. Here you will find electrical relays, sensors, switches, and modules for the engine, camshaft, and crankshaft. Our parts are OEM, Genuine BMW, or approved aftermarket brands that we have an excellent track record with. There is no middle ground with electrical parts - it either works perfectly or not. And there's nothing more frustrating than a new part that fails right out of the box. So it's important to choose quality replacement parts over a cheap but faulty piece.

Sub-Categories

Sort By:

Vargas MAP Sensor Extension Harness - BMW B58, N54, N55, S55, S58, S6...

2X Entries Into Our F80 M3 Sweepstakes

T#:51672717

Part#: VTT-MAP-HARNESS

Ships in 10 Business Days

$ 59.99 USD

Add to Wish List

Qty

$ 59.99 USD

Add to Wish List

As part of the VTT-FAB fabrication line, this extension harness is designed for builders and tuners who need flexibility.

Vargas Plug & Play Pre And Post Throttle MAP Sensor Kit - 6B 4W - BMW...

2X Entries Into Our F80 M3 Sweepstakes

T#:52129729

Part#: VTT56BSENSKIT64

Ships in 10 Business Days

$ 209.99 USD

Add to Wish List

Qty

$ 209.99 USD

Add to Wish List

The VTT 6-Bar MAP sensor kit provides the necessary overhead to monitor boost levels with a linear voltage scale that makes software calibration straightforward.

Walker MAP Sensor - BMW N20 N26 S55 S63

T#:39059258

Part#: 13627843531

Ships in 1 Business Day

$ 163.99

This product was last offered at the strikethrough price on
04-10-2026

$ 135.99 USD

Add to Wish List

Qty

$ 135.99 USD

Add to Wish List

This is a replacement Manifold Absolute Pressure sensor Located on the charge air cooler. The MAP controls the amount of fuel that goes through the injectors based on the pressure of air at the intake manifold. If your vehicle is giving you a MAP code, replace it immediately to ensure you get the best gas mileage and performance. It is common for this part to fail slowly and cause poor fuel mileage and hampered performance. When it fails, the vehicle will stutter and stall as it falls into a limp mode. One way to check if your MAP is bad is to unplug the connector before starting your car. If it idles well (compared to a previous poor idle), your MAP sensor likely needs to be replaced. If you let this maintenance part go, your fuel economy will suffer as too much fuel is going into the engine and not being burned. A great way to give your vehicle an efficiency boost.

Show More Show Less