Precision Raceworks' Fuel Injector Removal and Installation Tool is one of the highest-rated tools on the market, not only for removal and installation of injectors but also for the installation and compression of the high-pressure seals! For injector removal, simply thread the tool onto the input of the fuel injector and use the slide hammer to tap the injector out. When installing new seals, simply use needle-nose pliers to pinch the old seal and remove it. Once removed, the new seal can be installed using the included expansion tool found stored inside the shaft of the tool. The rest is as easy as 1, 2, 3! Insert the injector into die #1 and count to 10, then insert the injector into die #2 and count to 20, finally insert the injector into die #3 and count to 30, then install your injector.
Show More Show Less
From supplemental fueling to ignition systems and anywhere in between Precision Raceworks, LLC is known for being the premium product manufacture in the market. Precision Raceworks' BMW N55 replacement spark plug wires are the same plug wires that are included in their High-Performance N55 Ignition Kit. These wires are 100% custom design from the ground up by Precision Raceworks, the only company in the world to produce plug wires with boots specific for your N55 BMW to ensure proper fitment and quality. Plug wires are sold in packs of 6 so you get all new plug wires every time. So, replace the one you need and keep the rest for spares or replace all 6. All components used meet or exceed OEM requirements and feature seals that are both dust and water-resistant. Specifications: Weight: 1.8lbs Plug Wire Resistance: 50ohms per-ft Carbon Core: Yes Spiral Core Wire: Yes Silicone Insulation: 8mm High Performance Fiberglass inlayed for strength: Yes
Show More Show Less
The Precision Raceworks Phenolic Spacer is made in the USA from premium fiber impregnated phenolic material. With a Rockwell Hardness of 100 and a conductivity rating of 2.03 it is the perfect material for insulating between heat generating parts such as the cylinder head and other parts you wish to stay cool like the intake manifold. A phenolic spacer works by reducing heat transfer from the cylinder head to the manifold which results in reduction of intake air temperature, allowing for cooler air to enter the cylinders which is more dense and reduces chance of detonation in the cylinder. Our 1/2" phenolic spacer not only provides a thermal insulation between the cylinder head and intake plenum. It has also been designed to make use of factory O-Rings rather than messy gasket maker adhesive to ensure an air tight seal each and every time along with easy installation and removal.
Show More Show Less
