Turner Motorsport has everything you need to upgrade your BMW through our stages of performance or to keep your car in peak condition with our range of the latest in proven OEM cooling parts. Upgrade your cooling system and engine performance with the selections below to give your BMW a performance and reliability advantage.
This is a replacement Manifold Absolute Pressure sensor Located on the charge air cooler. The MAP controls the amount of fuel that goes through the injectors based on the pressure of air at the intake manifold. If your vehicle is giving you a MAP code, replace it immediately to ensure you get the best gas mileage and performance. It is common for this part to fail slowly and cause poor fuel mileage and hampered performance. When it fails, the vehicle will stutter and stall as it falls into a limp mode. One way to check if your MAP is bad is to unplug the connector before starting your car. If it idles well (compared to a previous poor idle), your MAP sensor likely needs to be replaced. If you let this maintenance part go, your fuel economy will suffer as too much fuel is going into the engine and not being burned. A great way to give your vehicle an efficiency boost.
Show More Show Less
Oxygen sensors measure exhaust oxygen. Their signals are used by the vehicle computer to adjust the air/fuel ratio and test vehicle emissions. Degraded oxygen sensors reduce engine performance and fuel efficiency, and increase harmful tailpipe emissions. They can also turn on the Check Engine Light and cause a car to fail an emissions test.
Show More Show Less
The camshaft position sensor communicates the position of the camshaft to the computer. This helps the computer to calculate proper spark and fuel control. If you're struggling with CELs, hard starts or no starts, stalling, and/or a rough idle, you may need to replace the cam position sensor.
Show More Show Less
Ignition coils are key to the efficiency and performance of your BMW. With a faulty coil, the spark plug is not burning the air/fuel mixture properly, and that can lead to problems anywhere in the engine and exhaust (including catalytic converters and O2 sensors). Problems with one or more coils will cause a fault code, but not always a check engine light. A misfire code may be related to an ignition coil, but could be from other things as well. Sometimes, a visual inspection of a coil and coil boot will give an indication of a failure. You can also move coils around to different cylinder banks to see if the misfire code follows a suspect coil. We suggest always having one or two coils on hand to keep as spares.
Show More Show Less
Oxygen sensors are used to adjust the air/fuel ratio and test vehicle emissions. Degraded oxygen sensors reduce engine performance and fuel efficiency, and increase tailpipe emissions. They can cause a car to fail an emissions test. Restore your emissions system with a new NOx Sensor from Vitesco.
Show More Show Less
This is the crankshaft position sensor. It provides information for the ECU. A faulty sensor can cause issues with timing adjustment and limit performance and vehicle operation. Replace your sensor with a high-quality Hitachi sensor to restore peak performance.
Show More Show Less