ECS for BMW F83 M4 S55 3.0L

Universal High-Flow Air Filter

Give your engine the airflow it deserves with this reusable, high-performance air filter—perfect as a direct replacement for an ECS intake system or as the finishing touch for your custom intake project.
Dimensions: 4.5" Base OD • 6" Filter Height • 3.5" Top OD

Upgrade from your restrictive factory filter to an ECS Tuning High-Flow Dry Air Filter and let your engine breathe freely. Improved intake flow enhances power throughout the rev range while helping maintain efficient fuel economy.

Oiled vs. Dry Filters — Which Is Right for You?

Oiled Filters

Offer slightly higher airflow for maximum performance

Require more frequent cleaning

Must be re-oiled after each cleaning

Long-term reusable design saves money over disposable paper filters

Dry Filters

Provide excellent airflow with minimal maintenance

Easily cleaned with warm, soapy water—no oiling required

Still flow significantly better than OE paper filters

Fully reusable and cost-effective

Both versions deliver superior performance over stock filters while offering the long-term benefit of reusability. Choose the option that best fits your maintenance style and performance goals.

Brake pad wear sensors are a convenient part of the braking system, notifying the driver of when the material on the brake pads are getting low and need to be serviced. Unfortunately it is common in custom or upgraded braking systems that the pad wear sensor is non-existent or does not mate properly with the connector on your vehicle, leaving you with a brake pad wear warning every time you start your vehicle.

ECS Tuning has developed this direct-fit Brake Pad Wear Sensor Bypass to alleviate this issue. This sensor bypass will trick the vehicle's electronics into thinking that the brake pads have adequate pad material to keep the dashboard warning from appearing. No more unnecessary warnings when installing a big brake kit or your own custom setup. This bypass is a plug-and-play component that requires no modifications so you can revert back to your OEM setup if necessary.

Some vehicles may be equipped with two front brake pad wear sensors, or a front and rear sensor, please be sure to double check the required quantity for your vehicle before placing an order.

*During installation, make sure to clean the mated female connector on your vehicle of any dirt or debris to ensure that the Brake Pad Wear Sensor Bypass is engaged securely.