BMW claims their transmission fluid to be a "lifetime" fluid, however is recommended to be changed every 60,000 miles to ensure a longer transmission life. Though not exposed to the same level of heat and contamination as engine oil, transmission oil still breaks down over time due to heat and becomes contaminated as your transmission wears. Old contaminated oil can lead to excessive wear and tear on sensitive transmission components which could lead to slow shifting, slips, and even complete failure. This is also true for the transmission filter integrated into the transmission fluid pan. The filter removes metal particles from the transmission fluid and eventually begins to clog, preventing fluid from passing through the filter easily. This leads to excessive wear and a reduced transmission lifespan if not changed. This high-quality Meyle transmission pan includes a new filter and is quintessential for a correct and full service.
Show More Show Less
Looking to upgrade your air filter for increased flow and performance? BMC filter allow significantly higher air flow and are perfectly molded in one piece to fit exactly the same as your stock air filter. These filters are constructed from multi-layerd cotton gauze that is pre-oiled and can be cleaned and regenerated using the BMC regeneration kit.
Show More Show Less
BMC air filters are produced using a "Full Molding" system that enables the characteristic red filter to be realized from a single mold with no welded joints thus avoiding easy breakage. The rubber used in BMC air filtering systems has a long life, is very durable and has optimum adhesion characteristics to all shapes of airboxes. BMC filters are made of a multi-layered cotton gauze soaked with low-viscosity oil covered with an epoxy-coated alloy mesh to ensure protection from petrol fumes and oxidization due to air humidity. All BMC air filters are pre-oiled, and they can be washed and regenerated by using the appropriate BMC regeneration kit. Replaces BMW P/Ns: 13718577170, 13718577171,13718691835
Show More Show Less
Accessory belt tensioners provide tension to the belt drive system, ensuring the belt is able to properly turn engine accessories without slipping. If your tensioner has failed, replace it with a brand-new unit to ensure proper water pump and alternator functionality.
Show More Show Less
For the front axle, fits left or right positions. A quality Meyle replacement wheel hub and bearing assembly that includes the four hub bolts. OE Cross Reference - 31402408654
Over the years, the road takes a serious toll on your suspension. Potholes, speed bumps, and road hazards all contribute to a sloppy, weak suspension. To give a better feel to your driving experience, change components as they wear to improve safety and ride comfort. One item to replace is the control arm. After years of service, the non-serviceable ball joints and other components can begin to wear out. Because some components cannot be replaced, the only solution is replacement of the entire arm. Turner Motorsport has your replacement with this Meyle-made piece, a high-quality aftermarket unit that will restore your suspension. A tighter feel, less shake in the steering wheel, and more solid performance when hitting road hazards such as potholes and bumps. Not only will you feel safe in your vehicle again, you can also feel comfortable. If replacing any part of your front or rear suspension, it is best to either do it in pairs (both left and right sides), or examine parts that are prone to failure. This will provide the most service life out of replacement parts and assure they are all performing properly. Skim through the suspension section of your vehicle model to see all those other parts that may need to be replaced.
Show More Show Less
