Oiling System for BMW 7 Series G11 (2016+)

Clear BMW chassis

Tasked with keeping everything properly lubricated, the oiling system is one of the most if not THE most fundamental parts of the engine. Make sure that everything is in good working order and flowing properly to ensure your engine has a long and trouble-free service life.

Sub-Categories

Sort By:

Oil Filter Housing Replacement Kit - BMW F22/23 F3X B58 3.0L ...

For earlier vehicles with the Gen1 B58 (B58A) - not compatible with the B58TU (B58D) en...

T#:27905122

Part#: 11428583895TKT

Ships in 3 Business Days

$ 540.99 USD

Add to Wish List

Qty

$ 540.99 USD

Add to Wish List

BMW's B58 engine has been very successful and has proved to be a reliable powerplant that is highly capable of producing some crazy power figures. Unfortunately, in true BMW fashion, the B58 engine does have a few problems that can become serious issues if not addressed quickly. One of these issues is the oil filter housing cracking and leaking engine oil and/or coolant. BMW chose to construct the oil filter housing out of plastic and the housing tends to split if the cap is tightened too tight or even just over time as the plastic becomes brittle from numerous heat cycles. Another common failure point is the multiple gaskets that seal the housing to the engine block and between the housing and the engine oil cooler. when these seals fail, you will notice coolant and/or oil loss, or even the mixing of engine oil with coolant. There is also the possibility of your oil filter collapsing inside of the filter housing and preventing proper oil filtration and flow, sometimes clogging the small oil channels in your filter housing as the oil filter begins to fall apart. Though this is more common with vehicles that see extended oil change intervals, such as 12K+ mile oil changes, we have seen some failures as soon as 5,000 miles after an oil change! Whatever the cause may be, the solution is almost always the same, replacement of the whole oil filter housing. We have put together a kit including the basic components needed to replace your oil filter housing and get your BMW back on the road! Included: Bremmen Engine Oil Filter Housing - Includes a new cap, seals, oil cooler, and oil filter Genuine BMW Oil Cooler Mounting Hardware Genuine BMW Oil Drain Plug Gasket Elring Intake Manifold Gaskets Elring Throttle Body Gasket Bav Auto Transmission Fill Plug (For Automatic models) Genuine BMW Installation Hardware Not included in this kit are the fluids that will need to be replaced or topped off after the installation of your new oil filter housing, including engine oil, G48 or HT-12 coolant (depending on what your BMW came with from the factory), and automatic transmission fluid for models with the ZF 8HP transmission.

Show More Show Less

Oil Drain Plug

T#:41188174

Part#: 11137535106TKT

In Stock

Sale - Save 29% $ 8.99

This product was last offered at the strikethrough price on
05-03-2026

$ 6.35 USD

Add to Wish List

Qty

Sale - Save 29%

$ 8.99

This product was last offered at the strikethrough price on
05-03-2026

$ 6.35 USD

Add to Wish List

Includes a one time use crush washer.

Oil Filter Housing Gasket Replacement Kit - BMW Gen1 and Gen2 B58 3.0...

T#:27871828

Part#: 11428583896TKT

In Stock at Vendor

$ 140.03 USD

Add to Wish List

Qty

$ 140.03 USD

Add to Wish List

One unfortunate problem BMW failed to address with the B58 engines is leaking oil filter housing gaskets. If your oil filter housing gaskets are leaking, you will notice a slow oil loss, pooling oil under your vehicle, and oil running down the left rear side of your engine block and on the side of your oil pan. This kit includes all-new gaskets to re-seal your filter housing plus Liqui-Moly oil and a new Hengst filter to get your car back up and running and leak-free!

Show More Show Less

Oil Filter - Priced Each

We Price Match - Give Us A Call or Chat!

T#:20155614

Part#: 11428575211

Special Order: No Guaranteed ETA

$ 21.99 USD

Add to Wish List

Qty

$ 21.99 USD

Add to Wish List

The most important component of your oiling system in your vehicle is the oil filter. It keeps contaminants from making their way through your engine and causing premature failure. Those small metal particles, if not trapped by the filter, would abrade all moving metal to metal connections within the engine and wear out components quickly.

Project Cars

SELECT YOUR BMW

Oiling System for BMW 7 Series G11 (2016+)

Sub-Categories

Oil Filter Housing Replacement Kit - BMW F22/23 F3X B58 3.0L ...

Oil Drain Plug

Oil Filter Housing Gasket Replacement Kit - BMW Gen1 and Gen2 B58 3.0...

Oil Filter - Priced Each

Select Vehicle

Purpose

Category

Brand

Price

Special Offers

Narrow Results