BMW Suspension Parts

This kit is contains all new strut and shock mounts and hardware needed when installing a new shocks and struts or aftermarket suspension on your vehicle. 

Fits the following BMW's

F22/23 228i 228i xDrive M235i M235i xDrive without EDC and production date up 03/2015 

F30 320i 320i xDrive 328d 328d xDrive 328i 328i xDrive 335i 335i xDrive without EDC and production date up 03/2015 

F32/33/36 428i 428i xDrive 435i 435i xDrive 

If E30 needs a little more pep in the corners, this is an excellent suspension package. H&R Sport springs and Bilstein Sport shocks for the E30 will lower the ride height for an aggressive stance and stiffer springs will improve handling and balance in the corners. This suspension is a favorite among our E30 fans because the car corners better without a punishing ride. Perfect for daily-driven E30s who want to carry more speed through the corners.

H&R Sport springs lower the ride height by 1.25" and stiffens the spring rate. Both combine to lower the car's center of gravity and reduce the amount of bodyroll in corners. The springs are progressive rate so their initial stiffness is actually very compliant and it becomes stiffer as the spring is compressed. This is great for street cars that see bumps and potholes where suspension compliance is key. Overall, they are about 40% stiffer than the stock original springs.

We use Bilstein Sport shocks as the dampers and they feature Bilstein's patented and innovative valving system. With this system, small bumps and impacts are absorbed as they should be. But the shocks stiffen for cornering and other suspension motions. It's the best of both worlds as the shock self-adjusts based on suspension motion. These fit with the stock strut and shock mounts, making for an easy and clean install.
 

Parts list:

• 1 set - H&R Sport Springs (50406)
• 1 pair - Bilstein Front Sport strut inserts (P36-0335 / 34-003350)
• 1 pair - Bilstein Rear Sport Shocks (B36-2027 / 24-020275)

Fitment note: Front strut inserts fit the larger 51mm strut housings. These were standard for all 6-cylinder E30s, all M3, and 1989-1992 318i/is. Other models used a smaller strut housing which requires a different Bilstein insert.

This item fits the following BMWs:
1984-1992 E30 BMW 325e 325es 325i 325ic 325is

Eliminate the most common sources of suspension slop with our all new Turner Suspension Refresh Kits that feature only OEM parts! We do not include any "cheap parts" in our refresh kits to ensure long-lasting reliability and noise-free suspension.

This Level 1 kit replaces:

Front Control Arms
Front Control Arm Bushings

This kit is contains all new strut and shock mounts and hardware needed when installing a new shocks and struts or aftermarket suspension on your vehicle. 

Fits the following BMW's

E36 318i/ic/is 323i/ic/is 325i/is/ic 328i/is/ic 

• rear sway bar bushing brackets, 33556780707
• bracket mounting screws, 07119907125
• rear sway bar links, 33556764428
• lower link mounting bolts, 07119903931
• upper link mounting nuts, 33326768884

Eliminate the most common sources of suspension slop with our all new Turner Suspension Refresh Kits that feature only OEM parts! We do not include any "cheap parts" in our refresh kits to ensure long-lasting reliability and noise-free suspension.

This Level 1 kit replaces:

Front Control Arms
Front Control Arm Bushings
Front Sway Bar End Links & Bushings
Front Ball Joints
New Hardware

These M3 rear guide rod arms are an upgrade for the non-M cars. The stock non-M arms are made from sheetmetal spot welded together at the ends. The arm tends to flex and bend under even moderate cornering loads. Factor in gripper tires and more torque and this arm is inadequate for stability and consistent handling. The M3 arms are one piece of aluminum offering greater strength and with a sealed monoball inner bushing that allows the arm to rotate (instead of twisting).

This package includes:

• Left M3 Guide Rod - 33322283547
• Right M3 Guide Rod - 33322283548

This H&R-Bilstein package replaces the M5's standard shocks and springs with more-capable bits from Bilstein and H&R. Using a stiffer spring will mean less weight transfer and bodyroll in corners and a slightly lower ride height for better aesthetics. This package will bolt in to any E34 M5 with the optional E34 Self-Leveling Delete Kit.

H&R Sport springs lower the M5's ride height by .8" in front and 0.3" in the rear and stiffens the spring rate. Both combine to lower the car's center of gravity and reduce the amount of bodyroll in corners. The springs are progressive rate so their initial stiffness is actually very compliant and it becomes stiffer as the spring is compressed. This is great for street cars that see bumps and potholes where suspension compliance is key. Overall, they are about 20% stiffer than the stock original springs.

We use Bilstein Sport shocks as the dampers and they feature Bilstein's patented and innovative valving system. On the E34, suspension travel is crucial especially with a lowered ride height. This suspension is stiff but delivers uncompromising handling. These fit with the stock strut and shock mounts, making for an easy and clean install. Because BMW used multiple combinations of front strut and strut mount we will need specific information from your car in order to send you the correct parts.
 

Parts list:

• 1 set - H&R Sport Springs
• 1 pair - Bilstein Front Sport struts
• 1 pair - Bilstein Rear Sport Shocks (rear self-leveling must be disabled or removed) We offer a Self Leveling Elimination Kit)

Fitment note: some very late E34 models were equipped with an EDC electronic damping system. This must be disabled to use this suspension.

This item fits the following BMWs:
1991-1995 E34 BMW M5 sedan

Replacing your struts and shocks? Don't forget the bushings! The rubber mounts for the shocks will go bad over time, especially if you drive hard or the roads are particularly rough. The shock mounts locate the front struts and rear shocks to the car - providing a quiet and vibration-free buffer between the road and the cabin. Shock mounts and bushings can wear out just like any other rubber part on the car. This leads to more noise and harshness reaching the chassis and may complicate your new suspension install. When installing new shocks, that is the perfect time to also replace the mounts. There is no additional time to install them, no special tools required, and doesn't take any extra time! If you re-use the original mounts you have the risk of them failing before your next shock replacement, doubling your labor costs. 

This item fits the following BMWs: 
2006-2012 E9X BMW All xi models - 325xi 328xi 330xi 335xi

This suspension package for the E93 convertibles will lower the ride height for a better stance and give you better handling. The stock suspension can be very soft with a lot of bodyroll. If you want your 'vert to handle more like a sports car and less like a town car, this is the right suspension for you.

H&R Sport springs lower the ride height as much as 1.3" in front and 1.2" in the back and stiffens the spring rate. Both combine to lower the car's center of gravity and reduce the amount of bodyroll in corners. The springs are progressive rate so their initial stiffness is actually very compliant and it becomes stiffer as the spring is compressed. This is great for street cars that see bumps and potholes where suspension compliance is key. Overall, they are about 30% stiffer than the stock original springs. Lowering amount will be less if replacing the factory sport suspension.

We use Bilstein Sport shocks as the dampers and they feature Bilstein's patented and innovative valving system. With this system, small bumps and impacts are absorbed as they should be. But the shocks stiffen for cornering and other suspension motions. It's the best of both worlds as the shock self-adjusts based on suspension motion. Bilstein Sport shocks work with these shorter springs because the only change Bilstein makes is a slightly longer shock. These fit with the stock strut and shock mounts, making for an easy and clean install.
 

Parts list:

• 1 set - H&R Sport Springs (50490-5)
• 1 - Bilstein Left Front Sport strut (35-120407)
• 1 - Bilstein Right Front Sport strut (35-120414)
• 1 pair - Bilstein Rear Sport Shocks (BE5-C039 / 24-120395)

This item fits the following BMWs:
2007-2012 E93 BMW 328i 335i - Cabrio

Eliminate the most common sources of suspension slop with our all new Turner Suspension Refresh Kits that feature only OEM parts! We do not include any "cheap parts" in our refresh kits to ensure long-lasting reliability and noise-free suspension.

This Level 1 kit replaces:

Rear Sway Bar End Links
Rear Trailing Arm Bushings
Rear Strut Mounts
New Hardware

Stay planted in the corners with this 328i and 335i suspension upgrade. The stock suspension does well to deliver comfort and control. But our E92 customers demand more and this H&R and Bilstein package is a step above the stock, delivering less bodyroll, better balance, and improved stance, and without sacrificing ride quality.

H&R Sport springs lower the ride height as much as 1.3" in front and 1.2" in the back and stiffens the spring rate. Both combine to lower the car's center of gravity and reduce the amount of bodyroll in corners. The springs are progressive rate so their initial stiffness is actually very compliant and it becomes stiffer as the spring is compressed. This is great for street cars that see bumps and potholes where suspension compliance is key. Overall, they are about 30% stiffer than the stock original springs. Lowering amount will be less if replacing the factory sport suspension.

We use Bilstein B8 shocks as the dampers and they feature Bilstein's patented and innovative valving system. With this system, small bumps and impacts are absorbed as they should be. But the shocks stiffen for cornering and other suspension motions. It's the best of both worlds as the shock self-adjusts based on suspension motion. Bilstein HD shocks work with these shorter springs because the only change Bilstein makes is a slightly longer shock. These fit with the stock strut and shock mounts, making for an easy and clean install.

Parts list:

• 1 set - H&R Sport Springs (50490-3)
• 1 - Bilstein Left Front Sport strut (35-120407)
• 1 - Bilstein Right Front Sport strut (35-120414)
• 1 pair - Bilstein Rear Sport Shocks (BE5-C042)

• This item fits the following BMWs:
  2007-2012 E92 BMW 328i 335i 335is - Coupe