Blow Off Valves & Diverter Valves for BMW X Series F25 (2011+)

Bring out the sound of your turbo with the ECS Atmospheric Diverter Valve Spacer! The ECS DV Spacer gives your N20 the sound of a blow off valve (BOV) with every gear change and every boosted throttle close! The strategically engineered vent slots allow you to boost on without a CEL (Check Engine Light).

FEATURES:

Anodized Black 6061-T6 aluminum

Features 3 radial slots to let out the “woosh” with optimal flow for all OEM DV types

Engineered to operate CEL-FREE!

Alignment holes for ease of installation

Includes pre-installed, captured Viton O-rings, resistant to chemical degradation

Includes Zinc-plated alloy steel socket head cap screws

Tested for performance and durability

INSTALLATION:

Remove Diverter Valve
Place the spacer onto the DV flange r
Re-install your original DV solenoid atop the spacer with the included longer hardware.
The wastegate actuator must be swung out of the way for install. Loosen both screws retaining the wastegate actuator, then remove the one closest to the actuator, allowing the actuator to swing out of the way. This will allow for ease of installation.

Turbosmart GenV Raceport BOV (Fits competitors 50mm / female style flange. No weld flange included)

The Race Port is renowned for its exceptional compactness and lightweight design tailored for turbocharged competition-level engines. With its innovative collar design and internal flow structures, this BOV stands out as 50% lighter and 25% smaller than competing models, yet it boasts an impressive flow rate of 330 CFM, making it the market's top-performing BOV in its category.

Fits Chargepipes With Tial/Turbosmart Flange

It is recommended for any vehicle where the boost pressure has been increased by an ECU software upgrade and for unmodified vehicles operating in warmer climates, as a solution to the many failures that have occurred, where the original rubber diaphragm splits, which causes a loss of boost pressure. Unfortunately the failure doesn’t always result in a check engine light as the valve can still be blown open by the boost pressure, so you may not be aware that you are losing power due to this.

Our alternative is a fully engineered solution offering significantly improved reliability. Our valve is piston based with no diaphragm to fail, and of all aluminium construction. It replaces the original unit with a pressure/vacuum operated piston valve that still also retains the desirable OEM ECU control over valve actuation.

This Blow Off, or Dump valve, is for the BMW N20 2.0 Turbo engines that have the electronically controlled bypass valve. It is recommended for any vehicle where the boost pressure has been increased by an ECU software upgrade and for unmodified vehicles operating in warmer climates, as a solution to the many failures that have occurred, where the original rubber diaphragm splits, which causes a loss of boost pressure. Unfortunately the failure doesn’t always result in a check engine light as the valve can still be blown open by the boost pressure, so you may not be aware that you are losing power due to this.

Our alternative is a fully engineered solution offering significantly improved reliability. Our valve is piston based with no diaphragm to fail, and of all aluminium construction. It replaces the original unit with a pressure/vacuum operated piston valve that still also retains the desirable OEM ECU control over valve actuation.