Turner Open Carbon Intake - Gloss - F22 M240i/xDrive, F30 340i/xDrive, F32 440i/xDrive - B58

Product Details

We are proud to present you with our long-awaited Turner Motorsport Carbon Fiber B58 Intakes for F2x/F3x Chassis! Like all of our Turner Motorsport products, our B58 intake was CAD-Designed in-house to give you the best performing, most beautiful intake we could possibly imagine for your B58 powered BMW. The best part? Our design seamlessly integrates with OEM ducting and stock mounting locations to give you a simple install and an OEM+ fit and finish. We believe this is the way the B58 engine bays should have come from the factory. It’s time to ditch all that plastic.

Our higher flow filter and intake design reduced post filter pressure by 0.2 psi over stock, allowing for gains across the entire RPM range - this reduced pressure drop also results in less stress on your B58’s turbo.

If you are looking for our Turner Motorsport Enclosed Carbon Intake, see  T#638252 

Key Features & Benefits:

• 2x2 twill weave carbon fiber, clear coated for UV protection
• Wrinkle Black Powder Coated heat shield
• Ovaled Intake tube for OEM quality fitment
• High flow cleanable Turner Motorsport air filter

Special care instructions:

• If clear coat gets scratched, reseal affected area with clear coat touch up
• To retain UV resistance and protect finish, wax with high quality carnauba wax

Our B58 Carbon Intake fits the following BMWs:
2014 - 2016 F22 M240i, M240i xDrive
2012 - 2015 F30 340i, 340i xDrive
2012 - 2015 F32 440i, 440i xDrive

Want more in-depth details? We’ve got you covered below:

Carbon Fiber Intake Tube:

• 2x2 twill weave carbon fiber, protected by a clear coat for UV protection
• Ovaled intake tube design allowing
• MAF scaling matches factory intake
• MAF sensor flange machined from 6061-T6, black anodized and bonded to the intake tube directly in the center of the tube for accurate temp/airflow reading
• Vacuum line port machined from 6061-T6, black anodized and bonded to intake tube
• Integrated carbon flange allows secure mounting of intake tube to our heat shield

Heat shield:

• One piece design manufactured from 12 gauge 5052 aluminum
• Wrinkle black powder coated

High Flow Air Filter:

• Conical high flow cleanable air filer
• 8 ply oiled cotton gauze
• Bellmouth filter flange inlet reduces turbulence and maximizes flow

*Click here for installation instructions.*

Not for sale or use in the state of California on any pollution-controlled vehicle as per the California Air Resources Board.

Prop 65 Warning

Kit Contents

Product Q&A

Lifetime Replacement

Fits These Cars