Transmission and Differential Tools for BMW E30 M3 S14 2.3L

Clear BMW chassis

Please ensure your correct model is selected

Servicing your transmission, differential, or mounts can be an involved, but necessary, process. Confidently approach your next service with all the tools you would need to complete the job successfully with our recommended service tools and equipment. You can find all transmission and differential service equipment for your next job on this page.
Sort By:

AGA Tools - Corporate Logo
T#:5175755
Part#: AGA-DSH-40
Ships in 7 Business Days
$ 222.00 USD
Free Shipping
$ 222.00 USD
Free Shipping
Now removing the driveshaft can be a single man job!
AGA Tools - Corporate Logo
T#:5189118
Part#: AGA-DSW-50
Ships in 7 Business Days
$ 199.00 USD
Free Shipping
$ 199.00 USD
Free Shipping
This tool is a must to properly disconnect the driveshaft.
AGA Tools - Corporate Logo
T#:5175654
Part#: AGA-SS-8-14-K
Ships in 7 Business Days
2% off MSRP $ 169.00
$ 165.99 USD
Free Shipping
2% off MSRP $ 169.00
$ 165.99 USD
Free Shipping
Due to minimal clearance, it’s difficult to get a hex socket in the gaps to remove plugs on rear differentials, transfer case and other engine drain/fill plugs.

AGA Tools - Corporate Logo
T#:5189117
Part#: AGA-STA
Ships in 7 Business Days
$ 181.99 USD
Free Shipping
$ 181.99 USD
Free Shipping
Easily torque your driveshaft to specifications.

OEM Tools - Corporate Logo
T#:597059
Part#: OEM27037
Ships Jul 3, 2025
$ 38.99 USD
Free Shipping on orders $49 and up
Fits Most Domestic and Import Vehicles
Kingsborne - Corporate Logo
T#:5423
Part#: TLS-33-28
In Stock
$ 18.99 USD
Free Shipping on orders $49 and up
This clutch alignment tool exactly replicates the shaft and splines of the vehicle's drive shaft. It is made of high quality polypropylene injected plastics and insures perfect alignment of the clutch. Extremely durable, the clutch tool can be used over and over again. A must for anybody replacing a clutch.

This item fits the following BMWs:
1970-1976 2002 BMW 1600 2002 2002tii
1984-1985 E30 BMW 318i 318is 318ic
1984-1991 E30 BMW 325e 325es 325i 325ic 325is 325ix M3
1982-1988 E28 BMW 524td 528e 533i 535i 535is M5
1982-1989 E24 BMW 633csi 635csi M6
Show More Show Less

Schwaben by Race Ramps - Corporate Logo
T#:366904
Part#: 006160SCH01AKT
In Stock
$ 677.99 USD
$ 677.99 USD

These ramps never scoot, slip or slide while rolling onto the ramps.All that said means these ramps are easy to drive up on and very safe. Our Schwaben ramps will never scratch or blemish your floors.

Having ramps to use offers more than just convenience, it offers safety. Laying under a car working is much easier to do knowing the car is resting the wheels on a firm surface.

Please refer to chart below to see if these 67" Schwaben ramps are right for you vehicle.

1. Take a yardstick, and wedge it under the front edge of front tire.

2. Raise it up until it hits the underside of your car( the spoiler)

3. Measure from the tip of the yardstick to the ground, vertically.

 67 " long,14" wide, 10" lift height, at 15 lbs each and a low 10.8 degree incline.

If your measurement is 7.25" or greater, you can clear these ramps with no problem. 

These extensions will lower your approach angle to 6.6 degrees. Once you get the car into place, you can remove the extensions for more working room under the vehicle. One set holds up to 3000 lbs.

For increased safety, use wheel chocks with all Schwaben Ramp products.

Show More Show Less
AGA Tools - Corporate Logo
T#:42638588
Part#: AGA-APIT
Ships in 7 Business Days
New Item
$ 495.00 USD
Free Shipping on orders $49 and up
This tool kit is designed to make removing/installing axles easier and prevent damage to the axle boot or dust seals on the axles.

AGA Tools - Corporate Logo
T#:26404886
Part#: AGA-8HP-PRT
Ships in 7 Business Days
$ 489.00 USD
Free Shipping on orders $49 and up

Schwaben by Race Ramps - Corporate Logo
T#:387954
Part#: 006143SCH01AKT
Ships Aug 19, 2025
$ 562.99 USD
$ 562.99 USD