Sensors for BMW X Series E84 (2013-2015)

Clear BMW chassis

When it comes to BMW and Mini, there is no shortage of sensors on your vehicle! Below you can find many of the crucial sensors that lead to error messages and check engine lights being displayed when a fault has occurred. Get your BMW/MINI back on the road with these Genuine BMW or high-quality OEM parts.

Sub-Categories

Crankshaft Sensors (2)

Sort By:

Burger Motorsport 4 BAR TMAP Sensor & Adapter - BMW N55/N54/S55 (2007...

T#:34885402

Part#: 4BAR TMAP

In Stock

$ 139.99 USD

Add to Wish List

Qty

$ 139.99 USD

Add to Wish List

Use these plug and play adapters to quickly adapt a 4bar TMAP sensor to your N54/N55/S55 BMW, raising the boost maximum boost range from 20psi factory up to 43psi.

Burger Motorsports 2007-2012 TypeA 4BAR Adapter - E82/88 E9X E6X N54 ...

T#:599636

Part#: TYPEA4BARADAPTER

Ships in 3 Business Days

$ 35.00 USD

Add to Wish List

Qty

$ 35.00 USD

Add to Wish List

Use these plug and play adapters to quickly adapt a 4bar TMAP sensor to your N54/N55/S55 BMW, raising the boost maximum boost range from 20psi factory up to 43psi. For very high boost applications, this 4 BAR adapter can be used which requires Bosch 4 BAR sensor (Part # 281002576). SENSOR NOT INCLUDED, Please see T#587716

Show More Show Less

Walker MAP Sensor - BMW N20 N26 S55 S63

T#:39059258

Part#: 13627843531

In Stock at Vendor

$ 163.99

This product was last offered at the strikethrough price on
04-10-2026

$ 135.99 USD

Add to Wish List

Qty

$ 135.99 USD

Add to Wish List

This is a replacement Manifold Absolute Pressure sensor Located on the charge air cooler. The MAP controls the amount of fuel that goes through the injectors based on the pressure of air at the intake manifold. If your vehicle is giving you a MAP code, replace it immediately to ensure you get the best gas mileage and performance. It is common for this part to fail slowly and cause poor fuel mileage and hampered performance. When it fails, the vehicle will stutter and stall as it falls into a limp mode. One way to check if your MAP is bad is to unplug the connector before starting your car. If it idles well (compared to a previous poor idle), your MAP sensor likely needs to be replaced. If you let this maintenance part go, your fuel economy will suffer as too much fuel is going into the engine and not being burned. A great way to give your vehicle an efficiency boost.

Show More Show Less