BMW Engine Parts for BMW 6 Series F06 (2013+)

Enhance your BMW's performance with the upgraded BAV Ignition Coil, designed to boost firepower and optimize engine efficiency. These coils boast modified core windings for a faster, more efficient burn, resulting in increased torque at lower RPMs and heightened horsepower in the upper range. While improvements depend on your engine's condition, these coils ensure noticeable enhancements in performance and potential fuel economy benefits.

Product Benefits:

Improved engine firepower and efficiency
Increased torque at lower RPMs
Enhanced horsepower in higher ranges
Potential improvement in fuel economy
Set of six for complete BMW Cooper replacement

Pulleys begin to squeak once they are reaching the end of their life span and the tensioners can fail, no longer applying enough tension to the accessory belt. If not replaced, tese can seize up and lead to a long host of problems that would leave you stranded on the side of the road. Prevent this with routine maintenance and replace your belts and pulleys every 50,000 miles to ensure continued reliability.

Fits the following BMW chassis:
F22/23 F87 F3X F07/10/11 F06/12/13 F01/02 F25/26 E70/71 F15/16

Fits the following BMW engines:
N55 3.0L, S65 3.0L

Enhance your BMW's performance with the upgraded BAV Ignition Coil, designed to boost firepower and optimize engine efficiency. These coils boast modified core windings for a faster, more efficient burn, resulting in increased torque at lower RPMs and heightened horsepower in the upper range. While improvements depend on your engine's condition, these coils ensure noticeable enhancements in performance and potential fuel economy benefits.

Product Benefits:

Improved engine firepower and efficiency
Increased torque at lower RPMs
Enhanced horsepower in higher ranges
Potential improvement in fuel economy
Set of eight for complete BMW Cooper replacement

The most common reason fuel pumps fail is a plugged or restricted fuel filter, which makes the pump work harder. When a fuel pump starts to go bad, you may experience lack of power, no start, bucking, sputtering, or the engine may stop running. If this is occurring be sure to replace it before you are left without a working a vehicle.

Bosch is one of the largest OEM producers of Genuine BMW and aftermarket parts in the world, providing parts for almost every major automotive manufacturer. Bosch has likely supplied many of the original electrical (and mechanical) parts for your BMW. Thanks to their quality, high durability, and reliability, you should expect a long service life from Bosch products.

As a leading source of high-performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts. All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

This is an OEM INA Idler Pulley, also known as the roller pulley or deflection pulley. The idler pulleys are known to be the primary sources for 'belt squealing'. The pulley is also encased in rubber which will crack over time. If left without service the rubber could fail completely, chucking the belt and leaving you stranded. Replacement is a very simple procedure and can be done anytime the fan is off the engine (belt replacement, water pump service, alternator replacement, etc).

 OEM Schaeffler (INA, LuK, & FAG) is an engineering company that focuses on high-performance, precision manufacturing. With their individual brands INA, Luk, and FAG providing exceptionally high quality parts directly to BMW, as well as countless other automotive companies, their history of reliability and variety of offered parts makes Schaeffler a go-to replacement parts provider for all of us here at Turner Motorsport.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

This item fits the following BMW Chassis:
E70,E71,F06,F07,F10,F12,F13,F15,F16,F01,F02,

Fits BMW Engines including:
N55

The oxygen sensor is vital to the performance and drivability of your car. The engine computer relies on data from the sensor to make adjustments in engine efficiency and performance. When your BMW oxygen sensor fails, the computer can no longer sense the air/fuel ratio, so it ends up guessing -- resulting in poor performance, poor gas mileage, and increased pollution. Make sure your BMW engine performs as it should, and doesn't use more fuel than it needs to, by simply changing your oxygen sensor today. There is no lifespan on O2 sensors but there are several fault codes that indicate a failed sensor (O2 monitoring, cat efficiency, O2 heating circuit, O2 readiness, and others). The O2 sensor is heated and has a self-calibration feature so once you get the codes or feel performance has suffered, a new sensor is a good starting point to get you back to peak performance. Bosch's Oxygen sensors are high quality and will give you the the longest and best performance for the price.

Bosch is one of the largest OEM producers of Genuine BMW and aftermarket parts in the world, providing parts for almost every major automotive manufacturer. Bosch has likely supplied many of the original electrical (and mechanical) parts for your BMW. Thanks to their quality, high durability, and reliability, you should expect a long service life from Bosch products.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

This item fits the following BMW Chassis:
E82,E90,E92,E93,F30,F34

Fits BMW Engines including:
N55 - up to 08/2013

This kit is designed to enhance performance by adding six supplemental low-pressure fuel injectors, capable of supporting 1000+ WHP on E85 and similar high-performance fuels.

Crafted with precision, the manifold spacers are CNC machined and anodized to ensure durability and prolonged service life. Each kit comes complete with all necessary installation hardware, a gasket set, and a plug-and-play fuel line adapter for seamless integration.

The Elite kit stands out with its sleek black anodized finish and includes an additional return port, an upgraded fuel line, and enhanced machining to accommodate a wider range of applications, including the BMW S55 engine.

A port injection controller is not included. This is required for a complete installation.

Are you running more E85 or making more power on pump gas than your HPFP (High-Pressure Fuel Pump) can support?

Fuel-it has developed a port injection kit for your S55 that will provide you with the additional fueling capacity that you need to be able to run up to 100% E85 on stock or upgraded turbos.

What is port injection?

Port injection is a kit that is installed between your intake manifold and the cylinder head that runs off the low-pressure supply to provide you with more fueling than your stock system is capable of.  It's a relatively easy system to install and does not require any permanent modification to your car.

Port injection kits are offered in five different packages to meet your needs:

Base port injection kit: (included in Bronze, Silver or Platinum Kits)

• Fuel-It! custom black anodized spacer for the intake manifold
• Fuel-It! custom black anodized fuel rail
• Black anodized aluminum and stainless steel hardware
• Dual fuel supply port for those that are running inlets in the stock location (email us for info)
• Optional return port for those that will be running an upgraded fuel pressure regulator 
• Six of the following:
  • Flow matched Bosch injectors (52#)
  • Extended length steel bolts for mounting your new spacer 
  • BMW OEM gaskets

Bronze kit includes:

• Base port injection kit
• Basic fuel line connection kit
  • Two custom Fuel-It! fittings to maintain your stock fuel line connections at the HPFP and the feed line as it enters the engine bay
  • -6an (3/8") upgraded fuel lines
  • High flow custom Fuel-It! "Y" adapter
  • -6an fuel rail connection

Silver kit includes:

• Base port injection kit
• Basic fuel line connection kit​
• An upgraded fuel line that completely replaces the stock fuel line

Platinum kit includes:

• Base port injection kit
• Basic fuel line connection kit​
• An upgraded fuel line that completely replaces the stock fuel line​
• Integrated ethanol sensor​
• Bluetooth and JB4 compatible ethanol analyzer
  • JB4 integration compatible 0-5volt
  • Bluetooth (iPhone or Android app must be purchased to use this feature)

*These kits are available for off-road use only

*All port injection kits are built to order.

*Ethanol Sensors don't actually read the ethanol content, the readings are based on the absence of gasoline, so if your fuel is contaminated, your ethanol readings may be artificially elevated.