Genuine BMW BMW Engine Parts

Don't neglect your motor mounts! Most stock BMW motor mounts are fluid filled and the stiffness of the mount depends on this fluid. But over time the fluid leaks out and the strength of the mount is greatly reduced. A worn motor mount allows the engine to twist and shift around. The harder you're driving the more shift will occur. As the engine is moving around it can contact other parts in the engine bay - usually cooling related. The mechanical fan can hit the radiator; the A/C compressor can hit a radiator hose, the exhaust will flex and may break. Twisting of the engine can also lead to shifting problems as the transmission twists with it. There are countless issues related to worn or compressed motor mounts so don't overlook these as a regular replacement item (every 50,000 miles).

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

This item fits the following BMW Chassis:
E46 Non-M
E85 Z4 2.5i/3.0i/3.0si
E89 Z4 3.0si

A cracked valve cover can cause a myriad of problems none of which are inexpensive. A simple oil leak may prove nothing more than a driveway nuisance; however, the damage that can occur as a result of low oil do more to drain the wallet. A small vacuum leak may cause only a minor hesitation but the reduced efficiency means less mpg's and more trips to the pump. This factory replacement valve cover will get you back on the road and ensure a solid and tight seal along the top end of the engine. 
When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

Genuine BMW Cylinder Head Cover -
This item fits the following BMW Chassis:
E71,E82,E90,E92,E93,F06,F10,F12,F13,F15,F16,F22,F25 X3,F26 X4,F30,F32,F33,F34,F36

Fits BMW Engines including:
N55
 

This is the Genuine BMW timing chain tensioner for BMW's with the M60 or M62 V8 engines.

When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

This item fits the following BMWs:
1993-1995 E34 BMW 530i 540i
1997-2003 E39 BMW 540i
1988-1994 E32 BMW 740i 740il
1995-2001 E38 BMW 740i 740il
1990-1999 E31 BMW 840i 840ci
2000-2003 E53 BMW X5 4.4i X5 4.6is
2000-2003 E52 BMW Z8 Alpina Roadster

This gas cap fits BMW E46 thru 1999 and E39 1999. This fuel filler cap is an original BMW part. A faulty gas cap can often be the cause a fault code and trigger a "check engine" light.

When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

This item fits the following BMWs:
1999 E46 BMW 323i 323ci 328i 328ci

1997-2003 E39 525i 528i 530i 540i M5
9/1/98-7/1/1999 E90 BMW 335i & 335xi

The intermediate shaft bearings are located in the engine block (an inner and outer bearing). The intermediate shaft is driven from the timing belt and spins the oil pump shaft. Whenever the engine is torn down and the block is chemically or thermally cleaned these bearings will need to be replaced. The bearings must be sized with the intermediate shaft! The bearing surfaces must be machined to the correct tolerance for the block and shaft! You must make your engine builder aware of this before final assembly.

Note: these bearings must be machined for the shaft and block.

M20 block uses inner and outer bearings but the bearings are the same part numbers.

When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

Genuine BMW Adapter Lead Ibs
This item fits the following BMW Chassis:
E60 M5,E63 M6,E63