Please ensure your correct model is selected
This product was last offered at the strikethrough price on
06-13-2026
This product was last offered at the strikethrough price on
06-13-2026
Whether you need a camber change or you are looking for more adjustment with your camber plates, you can change your camber by shimming the strut and spindle with the TMS bolt kit. There are some things to take into account with this kit so please read the installation tips below. An alignment is strongly recommended after installing this kit.
Click here for installation instuctions.
This item fits the following BMWs:
1992-1998 E36 BMW 318i 318is 318ti 318ic 323is 323ic 325i 325is 325ic 328i 328is 328ic M3
1997-2002 Z3 BMW Z3 1.9 Z3 2.3 Z3 2.5i Z3 2.8 Z3 3.0i M Roadster M Coupe
2006-2008 E85 E86 BMW Z4 M Roadster M Coupe
This product was last offered at the strikethrough price on
05-03-2026
This product was last offered at the strikethrough price on
05-03-2026
The motor mount area on a subframe is one of those easily-forgotton areas that may be hiding a serious problem. The subframe on the E36 has a gusset ('ear') welded on for the motor mounts. These gussets take the stress of the motor mount as the engine torques (more upgrades = more torque = more stress). Worn motor mounts only transfer more stress to the subframe. Unfortunately, the gusset is not well-reinforced from the factory and cracks can develop along the welds and the gusset begins to collapse. A total failure of the guesset will shift your engine to the side and forward, taking out many other components along the way and leading to a very costly repair. 
Click Here for Installation Instructions.
This product was last offered at the strikethrough price on
05-03-2026
This product was last offered at the strikethrough price on
05-03-2026
These bushings have the hole off-center to give your car a little more track, caster, and camber. This style came as standard equipment on E30 M3s (8/89-later) and 1995 E36 M3 but will work with any E30, E36, Z3.
Rubber control arm bushings are designed to flex and absorb energy. That's fine on a streetcar but on an all-out racing machine you want your alignment to stay constant. We have picked Delrin for this application due to its high rigidity and low coefficient of friction allowing for minimal suspension bushing deflection (geometry change) but decreasing bushing windup or drag (friction). They are not recommended for street-use but highly-recommended for track cars.
To save time, pick up a pair of new bushing carrier brackets and hardware. This will save you the time and hassle of pressing out the old bushings. This will especially save you time if you're buying new control arms at the same time (no time wasted removing the old brackets from the arms). Stainless steel set screws included.
This product was last offered at the strikethrough price on
05-03-2026
This product was last offered at the strikethrough price on
05-03-2026
This product reinforces the metal swaybar link mounting point on the rear trailing arm. The sheet metal breaks off the trailing arm due to the constant up and down loads being placed on the trailing arm from the swaybar. Problems increase when larger sway bars are used. This product eliminates the problem by thickening the sheet metal and triangulating the mounting point. A good time to install this kit would be when you are doing any rear suspension work, exhaust, or even if you are just doing a differential fluid change. This part requires welding for installation. Click here for installation instructions.
This product was last offered at the strikethrough price on
03-27-2026
This product was last offered at the strikethrough price on
03-27-2026
