BMW Intake Parts for BMW 5 Series E60 (2004-2010)

The factory plastic gears in BMW S65 and S85 throttle body actuators are notorious for premature wear due to mechanical stress, engine vibration, and heat cycling. Over time, this wear leads to excessive play, throttle response issues, and eventual failure. This can cause DME fault codes, limp mode, and DSC malfunctions. While replacing both throttle actuators is costly, even new OEM units will eventually suffer the same fate.

Thankfully, ECS has developed the ultimate solution for E9X M3, E60 M5, and E63/64 M6 owners! These Upgraded Throttle Body Actuator Gears are constructed of Teflon-reinforced nylon, significantly reducing friction and gear tooth wear for long-term reliability. Each gear comes pre-installed on a 4140 steel shaft, strengthening the assembly and ensuring a hassle-free installation. With this cost-effective and durable fix, you can eliminate throttle actuator failures for good!

Features & Benefits:

Upgraded Teflon-reinforced nylon gears – Superior to factory plastic-on-plastic gears, reducing wear and extending lifespan. Pre-installed 4140 steel shafts – Increases durability and simplifies installation. Prevents common actuator failures – Resolves worn gear issues that cause CELs, limp mode, and DSC/DME errors. Cost-effective alternative to full actuator replacement – Saves hundreds in parts and labor. Factory-like fitment – Engineered for precise compatibility and long-term reliability. Built to withstand heat and mechanical stress – Ensures consistent throttle performance and extended service life.

An easy way to improve the performance of your N54 powered BMW is by removing the stock air box and swapping in this Dual Cone Intake "DCI" from Burger Motorsports. Featuring two S&B inverted cone filters with adapter couplers and new hardware, these easily install into the stock box location, allowing for greatly improved intake air flow. This is great for both stock and modified vehicles, as this allows for greater air flow at all RPMs and removes the air restriction that would normally rob your engine of power.

In addition to increased power, these filters give your engine a more aggressive appearance and sound that any automotive enthusiast will appreciate.

MADE IN THE USA

**CARB Approved Under Executive Order (EO) No. D-744-2 for all 2007-2012 BMW models equipped with the N54 3.0L twin-turbocharged 6-cylinder engine.**

Has the idle gone crazy on your S85 V10 engine? This is the Genuine BMW idle control device for cars with the S85 V10 engine. The fuel injection idle control valves are sold individually.
When doing any sort of repair or maintenance there is no replacement for genuine factory parts. Turner Motorsport carries the Genuine BMW brand with pride and has the parts you need to complete your next project with confidence.

2006-2010 E60 BMW M5
2006-2010 E63 BMW M6

BMW E60 E61 N52 Cold Air Intake System aFe Magnum FORCE Stage-2 Pro 5R is designed to significantly enhance the performance of your BMW by replacing the restrictive factory air box. This intake system features a 1.6mm powder-coated steel heat shield and a heat-resistant molded intake tube, which is trim-sealed to prevent hot engine air from entering. The kit includes a custom aFe brand Pro 5R cotton filter, known for its high airflow and exceptional filtration.

• Enhanced Airflow: The Pro 5R filter media, lightly oiled gauze, maximizes airflow to the engine, improving horsepower and torque.
• Improved Performance: Removal of the restrictive factory air box increases acceleration and throttle response.
• Durable Construction: The 1.6mm powder-coated steel heat shield and molded intake tube provide long-lasting durability and protection.
• Custom Fit: Designed specifically for the BMW E60 525i and 530i models from 2006-2007.

This intake system is a high-performance upgrade that enhances engine efficiency and driving experience. For installation instructions, please refer to the provided link.

Due to weak plastic construction, the factory plastic crankcase ventilation breather hose is known to fail. After years of exposure to piping-hot engine bay temperatures and chemical-laden oil vapors, the corrugated plastic tubing can crack, crumble, or fail altogether.

We set out to bulletproof your N52 CCV system with a durable silicone breather hose, designed to provide a comprehensive upgrade and permanent replacement for the factory plastic hose. By replacing the flimsy, heat-hardened OEM plastic hose with a four-ply fluorosilicone hose, you'll experience peace of mind knowing your N52 is free from the inevitable return of oil leaks, vacuum leaks, and drivability concerns that would have been.

This breather hose is found at the front of the engine, and is used to connect the oil separator to the valve cover. It replaces OEM part number 11157522931.

Features:

Silicone construction ensures a durable replacement that is sure to outlast OE plastic
Designed as a direct replacement for the factory breather hose
Retains heating function and OE electrical connector
Design:

Four-ply wire-reinforced fluorosilicone hose is designed to resist degradation due to exposure to oil vapors
O-rings are pre-installed in OE connectors for a lasting seal
Includes pre-installed zinc-coated hose clamps for durability and corrosion resistance
Product Development:

Our Silicone CCV Hose Upgrade was designed, engineered, tested, and quality inspected by our Research and Development team in our Wadsworth, Ohio, facility. We strive for the highest level of precision and quality through leading-edge product development technology, including FARO laser scanning for reverse engineering and quality inspection, SolidWorks 3D CAD modelling, rapid prototyping utilizing our in-house 3D printer, and rigorous long-term product testing.

A faulty throttle body can cause poor engine operation or even complete failure to function. Replace your malfunctioning throttle body with a high quality OEM VDO unit to restore proper engine operation. 

OEM VDO is one of the largest OE providers in the world, supplying numerous vehicle brands, including BMW, with many of their genuine parts that build the vehicle before they ever reach the car lot. Entrusted by many of the top names in automotives and with their proven history of reliability, it makes all of us here at Turner confident that their line of OEM replacement parts are a perfect option to restore your vehicles original operation and performance. The same great quality or higher than Genuine BMW parts at a lower cost.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

A faulty throttle body can cause poor engine operation or even complete failure to function. Replace your malfunctioning throttle body with a high quality OEM VDO unit to restore proper engine operation. 

OEM VDO is one of the largest OE providers in the world, supplying numerous vehicle brands, including BMW, with many of their genuine parts that build the vehicle before they ever reach the car lot. Entrusted by many of the top names in automotives and with their proven history of reliability, it makes all of us here at Turner confident that their line of OEM replacement parts are a perfect option to restore your vehicles original operation and performance. The same great quality or higher than Genuine BMW parts at a lower cost.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!