BMW Control Arm Replacements & Upgrades for BMW 1 Series E82 (2008-2013)

Bushings tends to wear over time and split or even break free from the internal sleeve, causing excessive movement and sloppy control feel. OEM Lemförder bushings are the perfect option to restore suspension back to day 1 quality.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

Genuine BMW Rubber Mount, Roll-Over Strut
This item fits the following BMW Chassis:
E82 1M Coupe,E82,E90,E92,E93,F80 M3,F82 M4,F83
 

Run into a curb a little too hard? BMW designs these toe arms to bend in the event of an accident, to save more expensive components from damage. 

If you are looking for an aftermarket adjustable option, Turner Motorsport recommends SPL Parts e9x Adjustable rear toe arms

Genuine BMW Repair Kit For Track Control - 33322406290

When an E9X is lowered beyond the limits of just lowering springs, the rear wheels toe-in excessively. This excessive rear toe leads to premature wear, that many people attribute to an increase in negative camber. It has become a common belief that an extremely low vehicle will wear the tires wrong as a matter of consequence. It has become standard practice to go as low as you can and proceed to replace your tires every five to ten thousand miles. Whats more is that when the vehicle reaches a certain ride height, the factory arms become maxed out and there is no way to compensate and dial in the proper toe. You're left with an improperly aligned vehicle that is in effect worse off than it was with the stock suspension installed.

This is not only uneconomical but improper and unsafe. ECS Tuning is proud to offer a solution for this problem in the form of Rogue Engineering E9X adjustable rear toe arms. These arms allow for greater toe adjustment on vehicles that have been lowered with a coilover suspension. With the toe set properly the tires can contact the road properly this maximizes grip and minimizes wear. 

Features:

• 100% machined and anodized, 6061-T6 lightweight aluminum arms
• High-strength, 3-piece, rod end (with carbon fiber reinforced, PTFE race) offers longer life for street compared to standard rod ends
• SEALS-IT Rod end seals keep dirt, water, and other contaminants out
• Rod ends feature grease fittings, to allow for rod end serviceability.
• Lighter than stock!  (Stock is 875g, RE arms are 640g)
• Extremely easy installation and adjustment (your alignment shop will LOVE you!)

Worn control arm bushings can cause steering slop and overall inhibit your vehicle's performance. This listing is for a Genuine BMW front inner control arm bushing.

If you're looking for a more track friendly setup and are not interested in pressing in your own bushings, check out our Turner e82 e88 e9x e84 z4 Thrust arm monoball upgrades! 

However, if you're looking for a caster adjustable bushing, SPL Parts makes caster adjustable bushings

BMW E82 E9X M3/1M Front Control Arm Upgrade Kit is the perfect performance upgrade for enhancing your BMW's handling without sacrificing ride quality. This upgrade kit features significantly sturdier control arms with stiffer bushings and ball joints, providing a major improvement over your factory components. Ideal for replacing worn-out stock arms, this kit offers increased precision in handling, a sportier ride, and approximately 0.75 degrees of added negative camber to the front, improving cornering capabilities.

Included in this kit are all four M3-specific lower control arms, as well as an M3 headlight leveling rod for proper installation. It's an essential upgrade for drivers looking to boost their BMW's performance while maintaining roadworthiness.

• Stronger control arms for enhanced durability
• Stiffer bushings and ball joints for improved handling
• Adds approximately 0.75 degrees of negative camber for better cornering
• Provides a sportier, more precise ride without compromising comfort
• Includes M3 headlight leveling rod and all four M3-specific lower control arms

BMW E9X M3/1M Rear Upper Control Arm Upgrade Kit is the ultimate solution for enhancing control and handling in non-M 1 or 3-Series vehicles. This upgrade is not only highly recommended but is one of the most effective enhancements available. The M3 control arms are crafted from solid aluminum, replacing the factory's weak sheet-metal control arms. This is crucial for BMWs equipped with power upgrades or sportier tires, as the factory arms tend to flex and twist, leading to instability and unpredictable handling.

Key features of the M3 control arms include a robust design with a sealed monoball bushing, allowing for rotation instead of twisting. This results in significantly more predictable and precise handling without sacrificing ride quality. There are no downsides to this upgrade.

Kit Includes:

• M3 rear upper guide links
• M3 rear upper wishbone arms
• ABS brackets

For additional enhancement, subframe bushings and sway bars from the M3 can also be integrated.

Benefits:

• Improved Handling: Provides precise steering response and enhances overall vehicle control.
• Enhanced Durability: Solid aluminum construction offers superior strength compared to factory options.
• Easy Installation: Designed for a direct fit, making upgrades straightforward.
• Seamless Compatibility: Works well with existing components and further upgrades.