Emissions System for BMW Z Series E85/6 (2003-2008)

The oxygen sensor is vital to the performance and drivability of your car. The engine computer relies on data from the sensor to make adjustments in engine efficiency and performance. When your BMW oxygen sensor fails, the computer can no longer sense the air/fuel ratio, so it ends up guessing -- resulting in poor performance, poor gas mileage, and increased pollution. Make sure your BMW engine performs as it should, and doesn't use more fuel than it needs to, by simply changing your oxygen sensor today. There is no lifespan on O2 sensors but there are several fault codes that indicate a failed sensor (O2 monitoring, cat efficiency, O2 heating circuit, O2 readiness, and others). The O2 sensor is heated and has a self-calibration feature so once you get the codes or feel performance has suffered, a new sensor is a good starting point to get you back to peak performance. Bosch's Oxygen sensors are high quality and will give you the longest and best performance for the price.

This is the OEM Bosch oxygen sensor for BMW's with the N52, N54, and N55 3.0L engines. This 560mm bank 1 oxygen sensor is mounted after the catalytic converter.

Bosch is one of the largest OEM producers of Genuine BMW and aftermarket parts in the world, providing parts for almost every major automotive manufacturer. Bosch has likely supplied many of the original electrical (and mechanical) parts for your BMW. Thanks to their quality, high durability, and reliability, you should expect a long service life from Bosch products.

As a leading source of high-performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts. All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

Connecting the cyclone oil separator to the engine valve cover, this hose is crucial for maintaining optimal engine performance. Over time, exposure to heat from engine components can cause the plastic hose to become brittle, resulting in cracks, tears, or splits. These issues can lead to vacuum and oil leaks, triggering a check engine light.

• High-quality replacement for BMW crankcase vent hose
• Ensures optimal engine performance
• Resistant to heat and wear
• Helps prevent vacuum and oil leaks
• Easy to install

For your BMW's optimal performance, ensure the functionality of the hose connecting the oil dipstick to the crankcase vent valve. Positioned below the intake manifold, this hose is susceptible to clogging with oil film and condensation, leading to potential failure over time. Cracks and swelling in old hoses can result in oil and vacuum leaks, compromising engine performance.

• Essential component for BMW engine functionality
• Prevents clogging and potential hose failure
• Minimizes oil and vacuum leaks
• Convenient replacement when replacing crankcase vent valve

This tube runs from the oil separator to the lower dipstick tube.

BMW has an ongoing issue with oil separators freezing in cold weather if driving is done before the vehicle is fully warmed up. There is often a howling noise followed by numerous oil leaks. The crankcase breather valve is used to purge the oil vapor from the engine block into the valve cover. However, sometimes condensation can cause it to freeze, causing the entire oil separator system to fail, crack, and disintegrate.

Replace this and all the other components of the oil separator system to prevent damage to all the aspects of your engine. As long as you have everything off, you can rest assured that new parts will last and be reliable.