BMW Fuel System Parts for BMW 2 Series F22 (2014+)

Clear BMW chassis

Looking for a BMW fuel pump, BMW gas cap or other BMW fuel system related items? You've found the right place. Your BMW fuel delivery system is a critical system, and any failure can rended your BMW dead in the water. Whether your fuel pump has stopped pumping, a fuel injector is clogged or not spraying, or your gas cap is either lost or not properly sealing, we likely have what you are looking for. We stock thousands of BMW fuel system parts so if you don't see what you are looking for, just give us a call.

Sub-Categories

Sort By:

Spool Performance B58 Stage 3 Low-Pressure Fuel-pump DIY Kit ...

T#:640940

Part#: SP-BMB58-FP-DY

Special Order: No Guaranteed ETA

$ 499.00 USD

Add to Wish List

Qty

$ 499.00 USD

Add to Wish List

LPFP upgrade kit for your B58 engine - Save by assembling on your own!

Spool Performance N55 Stage 3 Low-Pressure Fuel-Pump

T#:640951

Part#: SP-BMFXXN-FP

Special Order: No Guaranteed ETA

$ 749.00 USD

Add to Wish List

Qty

$ 749.00 USD

Add to Wish List

Stage 3 LPFP upgrade kit for your N55 engine

BMW GEN2 Upgraded High Pressure Pump B58

T#:31291063

Part#: SP-B58-FX350-NEY

Special Order: No Guaranteed ETA

$ 2,348.00 USD

Add to Wish List

Qty

$ 2,348.00 USD

Add to Wish List

The FX-350 is truly Plug and Play for all platforms we are offering and comes with all the lines and hardware needed for a clean easy install.

SPOOL FX-200 Upgraded High Pressure Fuel Pump - BMW N55

T#:26271786

Part#: SP-FX-200-N55-NE

In Stock

$ 1,799.00 USD

Add to Wish List

Qty

$ 1,799.00 USD

Add to Wish List

The FX-200 is an advanced high-pressure fuel pump engineered specifically for the BMW N55 engine, replacing our previous FX180 model. Featuring a larger bore size than the stock pump, it provides nearly double the flow rate. This pump is fully E85 fuel compatible and integrates seamlessly into the system without requiring any wire cutting or splicing. The enhanced flow capacity enables the use of higher ethanol concentrations and supports sufficient fueling for larger turbochargers.

Show More Show Less

PFS Port Injection Kit - B58

Aftermarket charge pipe required

T#:5663657

Part#: PFS-B58-PI

Ships in 10 Business Days

Starting at $ 733.99 USD

Add to Wish List

Starting at $ 733.99 USD

Add to Wish List

The kit includes all the parts needed for installation and has a choice of 550CC, or 900CC US-made DW injectors (larger available by request), and a Motiv Reflex Controller

Vargas HPFP Block-Off Plate - BMW B58 & S58

T#:51672724

Part#: VTT-X58-HPFP-BLO

Ships on Aug 7, 2026

$ 99.99 USD

Add to Wish List

Qty

$ 99.99 USD

Add to Wish List

The VTT Billet B58 HPFP Block-off Plate allows you to cleanly remove the bulky factory pump, reducing engine bay clutter and weight.

B58 High-Pressure Fuel-pump | Spool Performance

T#:640931

Part#: SP-FX-150-B58

Special Order: No Guaranteed ETA

$ 1,399.00 USD

Add to Wish List

Qty

$ 1,399.00 USD

Add to Wish List

B58 High-Pressure Fuel-pump | Spool Performance delivers exceptional performance for BMW enthusiasts seeking to upgrade their vehicle’s fuel system. Designed by the innovative engineers at Spool Performance, this high-pressure fuel pump significantly enhances fuel flow and power, making it an ideal choice for those looking to push the limits of their BMW's performance.

Increased Flow Rate: Provides 50% more flow compared to stock pumps (Stock @ .954 cc per rev vs. FX-150 @ 1.43 cc per rev).
Enhanced Fuel Limits: Supports larger turbos and higher ethanol concentration blends for increased performance.
Easy Installation: Plug-and-play design for straightforward installation.
E85 Compatibility: Suitable for use with E85 fuel blends.
Lifetime Warranty: Backed by a lifetime warranty from Spool Performance.

Important Note: The upgraded pump requires calibration changes before installation to prevent damage and warranty voidance. Ensure these changes are applied prior to starting the vehicle with the new pump installed.

Show More Show Less

Spool FX-200 Upgraded High Pressure Pump + Fuel Line [B58]

T#:15976515

Part#: SP-FX-180-B58

Special Order: No Guaranteed ETA

$ 1,899.00 USD

Add to Wish List

Qty

$ 1,899.00 USD

Add to Wish List

NOTE: This kit includes the optional Stainless Steel High Pressure Fuel Line offered by Spool The FX-180 is an upgraded high-pressure fuel pump for the BMW B58 motor. The pump features a bigger bore size than stock that translates into roughly 80% more flow when compared to stock. The pump is completely E85 compatible and fully plug and play with no cutting or splicing of any kind required. The added flow will let you run much higher ethanol concentrations and also allow fueling for bigger turbos. Flow Rates based on B58 stock CAM lift: Stock B58 Pump - 0.954 cc per rev FX-180 - 1.7 cc per rev Why do you need it? The stock HPFP on B58 motor is severely limited in capacity when trying to tune and raise the output of the motor. The FX-180 adds 80% more flow to the equation, raising the fueling limits on the platform and helping you run bigger turbos and/or higher ethanol concentration blends. Are tune changes required? The upgraded pump does require calibration changes. It is important to apply these changes prior to starting the car with pump installed to avoid any possible damage and void of warranty. Spool Performance can provide calibration details to your existing tuner and/or help you connect with established tuners who are experienced with these pumps. Custom tuning is required to get maximum output out of the upgraded pump setup for your specific vehicle setup and ambient conditions. Spool Performance is a hardware manufacturer and does not provide custom tunes, but can assist with questions your tuner may have. Low Pressure Fuel Pump Upgrade: Proper low pressure fueling is extremely important for proper functioning and durability of the high pressure pumps and injectors in a DI system. Inadequate low pressure fueling can cause damage to the pump piston and bore as they are lubricated by controlled leakage of fuel. Resulting damage from low pressure starvation is detectable and would be cause for voided warranties. Please make sure you plan out your fuel system build with proper low pressure upgrades when necessary. NOTE: NOT COMPATIBLE WITH B58TU ENGINE

Show More Show Less

B58 Stage 3 Low Pressure Fuel Pump - New Bucket Build

T#:20320741

Part#: SP-BMB58-FP

Special Order: No Guaranteed ETA

$ 1,148.99 USD

Add to Wish List

Qty

$ 1,148.99 USD

Add to Wish List

Spool FX-200 BMW N20 N26 Upgraded High Pressure Pump

T#:37385971

Part#: SP-FX-200-N20-NE

Special Order: No Guaranteed ETA

$ 1,799.00 USD

Add to Wish List

Qty

$ 1,799.00 USD

Add to Wish List

Upgraded Low Pressure Fuel Pump Assembly

Call In Or Chat For Best Price!

T#:14188788

Part#: R420-0002

Back Ordered

11% off MSRP $ 1,631.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 1,449.99 USD

Add to Wish List

Qty

11% off MSRP

$ 1,631.99

MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.

$ 1,449.99 USD

Add to Wish List

As power output increases, the demand for low-pressure fuel pumps increases. This kit includes components to upgrade your low-pressure fuel pump to deliver consistent fuel flow regardless of the amount of fuel inside the tank while increasing tank drawing. Best of all, the modified pump can be properly controlled by the DME and will result in no fault codes. Complete modified fuel pump Increases tank draw Consistent fuel flow Works seamlessly with existing DME For over 35 years, Dinan has been America's premier tuning company, pioneering advancements in BMW modification while retaining a focus on balanced performance that preserves the original character and driving feel that a BMW offers. When you install a Dinan part on your car, know that it's not only carefully developed and tested, but that Dinan stands behind it with a four-year, 50,000-mile warranty. Dinan believes so fully in their “total package” approach that once your car has been fitted with enough of their parts, they celebrate your conversion from stock to Dinan with an exclusive trunk badge, displayed proudly by BMW enthusiasts everywhere.

Project Cars

SELECT YOUR BMW

BMW Fuel System Parts for BMW 2 Series F22 (2014+)

Sub-Categories

Spool Performance B58 Stage 3 Low-Pressure Fuel-pump DIY Kit ...

Spool Performance N55 Stage 3 Low-Pressure Fuel-Pump

BMW GEN2 Upgraded High Pressure Pump B58

SPOOL FX-200 Upgraded High Pressure Fuel Pump - BMW N55

PFS Port Injection Kit - B58

Vargas HPFP Block-Off Plate - BMW B58 & S58

B58 High-Pressure Fuel-pump | Spool Performance

Spool FX-200 Upgraded High Pressure Pump + Fuel Line [B58]

B58 Stage 3 Low Pressure Fuel Pump - New Bucket Build

Spool FX-200 BMW N20 N26 Upgraded High Pressure Pump

Upgraded Low Pressure Fuel Pump Assembly

Select Vehicle

Purpose

Category

Brand

Price

Special Offers

Shipping

Narrow Results