BMW Brake Pads

The Hawk DTC (Dynamic Torque Control) compound offers the highest friction coefficient of any Hawk pad. The DTC pads offer extremely high torque with aggressive controllable initial bite, superior release and torque control characteristics. These DTC-60 pads have less torque than the similar DTC-70 pads.

Featuring:

• High Intial Bite
• Consistent torque over all pressures
• Operating Range:400-1600°F; 204-871°C
• High Temp & High Torque
• Provides Superior Pad and Disc Wear
• Excellent Torque Control
• Excellent Modulation and Release Characteristics
• Designed for High Deceleration Rates.

*Not for vehicles with Carbon Ceramic brake rotors.

Experiencing a brake warning light, squealing, grinding, or pulsation in your Mini? These signs often signal the need for attention to your brake pads. Upgrade to these replacement pads for improved braking performance, ensuring faster, safer, and quieter stops. This set comes equipped with essential hardware to prevent brake noise, like squealing or clunking, and to promote even wear. Here are the key benefits:

• Addresses brake warning lights, squealing, grinding, and pulsation
• Enhances braking performance for quicker, safer, and quieter stops
• Includes necessary hardware to prevent brake noise and ensure even wear

These low dust pads are specifically designed for daily driving, promising cleaner wheels and a smoother driving experience.

These are the OEM Pagid rear brake pads to fit the front of the specific BMWs listed below. BMW used several different suppliers for their brake pads and we buy direct from their distributors to get you the same pad as originally equipped but at a fraction of the cost of the local BMW dealer. OEM brands include Pagid, Textar, Jurid, Ate, and others. These are the same pads as what originally came on your car but without the expensive BMW logo.

This item fits the following BMWs:
2011+ F10 BMW 528i 528i xDrive 535i 535i xDrive 535d 535d xDrive
2011+ F25 BMW X3 xDrive28i X3 xDrive28d X3 xDrive35i
2015+ F26 BMW X4 xDrive28i X4 xDrive35i

The RSL29 pad is an endurance racing compound with long life and great wear characteristics. It has stable friction over a broad temperature range which makes them a very easy to use and predictable braking pad in a lot of environments. An evolution of the RSL19 endurance pad designed for more advanced drivers. This compound combines the outstanding wear rate of the RSL19 with a slightly higher coefficient of friction and initial bite. RSL29 also features improved hot fade resistance over the RSL19. In addition to the endurance racing, this pad will also be found in GT and VLN classes and Touring Cars (including our own E46 World Challenge cars). BMW has been using Pagid Yellow pads on their Nurburgring test vehicles and Ring Taxi for years.

This is the set of Rear pads.

This item fits the following BMWs:
2004-2010 E60 BMW 535i 545i 550i M5
2004-2011 E63 E64 BMW 645ci 650i M6
2011+ E82 BMW 1M - Coupe
2008-2013 E90 BMW M3 - Sedan
2008-2013 E92 BMW M3 - Coupe
2008-2013 E93 BMW M3 - Convertible

The latest in the Yellow line takes all of the RSL29 characteristics and adds a bit more aggressive behavior. Friction levels go up for more initial bite and better fade resistance. Modulation and release stays close to RSL29 levels. Pad and rotor wear is a little more than on the previous Yellows but still within reasonable levels and the RSL1 is still considered an extended endurance pad. Its development stemming from GT classes at Le Mans and Nürburgring.

Since Pagid pads tend to "out-gas" we recommend using these pads with a new gas-slotted or cross-drilled rotor for the best performance. Pagid brake pads are not compatible with previously used rotors, especially if used with a carbon or Kevlar based race pad.

This item fits the following BMWs:
2008-2013 E82/88 BMW 135i, 128 with BMW Performance caliper conversion
2006-2009 E9X BMW Submodels with BMW Performance caliper conversion