Packaged by Turner for BMW 1 Series

• 11127582245 - N52 valve cover gasket set
• 11127552280 - N52 eccentric shaft sensor seal
• 11127559699 - N52 Valvetronic gasket

If your vehicle is experiencing cooling issues, chances are the thermostat is the cause. Common symptoms include prolonged warm-up at highway speeds from the thermostat being stuck open, or consistent overheating issues from the thermostat being stuck in the closed position. Either condition can result in poor performance, and potential damage to vital components in your vehicle.

Kit includes

• Wahler Thermostat
• 1 liter of Coolant

This item fits the following BMWs: 
2008-2013  E82 BMW  135i 135is 1M Coupe 
2013+  E84 BMW  X1 xDrive35i 
2011  E90 BMW  335i 335xi 335i xDrive - Sedan 
2011-2013  E92 BMW  335i 335xi 335i xDrive - Coupe 
2011-2013  E93 BMW  335i Convertible 
2011-2013  E70 BMW  X5 xDrive35i 
2011-2013  E71 BMW  X6 xDrive35i

Tired of dealing with excess shifter slop and a mushy shifter? The Turner Shifter Rebuild & Upgrade Kits will restore your shifter's crisp feel and eliminate excessive movement that develops over time with wear. Included in this kit are all the common wear components and upgraded bushings that will give you a tighter shifting feel than traditional rubber bushings and will resist wear significantly longer.

This kit is perfect to restore your driving pleasure and will be the last shifter rebuild you will ever need!

See the included components under Kit Contents below.

This kit is contains all new strut and shock mounts and hardware needed when installing a new shocks and struts or aftermarket suspension on your vehicle. 

Fits the following BMW's

E82/88 128i 135i

E90/92/93 325i 328i 330i 335i 335is 

Drive line slop is often caused by faulty engine and transmission mounts. This can result in knocking noises under heavy acceleration, excessive vibration, and a less responsive feel in power. These OEM Lemforder and Corteco mounts are perfect to eliminate these problems and provide long lasting reliability.

Included in this kit:

• OEM Corteco Engine Mount (x2)
• OEM Lemforder Transmission Mount (x2)
• New Installation Hardware

When replacing your worn out brakes, the market is flooded with performance options. If your BMW doesn't see track time, it's not very practical. Performance pads and rotors tend to result in a lack of bite at low braking temperatures and cause excessive noise in daily driven vehicles that becomes irritating. BMW brakes from the factory are perfectly suited for trips around town, across the country, and even the occasional spirited driving session, delivering smooth, quiet, and long lasting performance. 

Included in this E9X BMW brake package are all of the OEM equivalent components needed to replace your Front & Rear brakes with comfort, reliability, and optimal lifespan in mind.

Brake components in this kit:

• Pagid Front & Rear Brake Pads
• Zimmerman Front & Rear Rotors
• New Front & Rear Wear Sensors
• Brand New Stainless Steel Set Screws
• Syl-Glide Silicone Brake Lubricant 

Fits the following BMWs:
2006-2013 E9X BMW M3
2011-2012 E82 BMW 1M

Often an oversight in maintenance, ignition components are also susceptible to wear and tear. Spark Plugs can accumulate carbon, reducing the spark intensity and it's ability to properly ignite the air/fuel mixture, leading to misfires and generally declining performance. Other ignition components, such as coils, boots, wires, caps, and rotors, can also wear out over time due to factors like heat and contamination, preventing the current from reaching the spark plug.

To start over fresh with all new components, we now offer these Ignition Service Kits. Each kit comes with brand new OE quality components, replacing any potential fault points in your ignition system for peak performance!

See kit contents below for a complete list of included components.

This kit includes every thing needed to replace your rod bearings.

Kit includes

Upper and lower WPC-treated rod bearings Hardware Oil filter BMW TwinPower Turbo Oil Oil pan gasket RedLine assembly lube

Automatic transmissions are reliable, shift smoothly, and can last without issue so long as they are properly maintained. Over time, the transmission fluid becomes thick and the filter becomes contaminated with small metal particles. This can cause excess wear, high transmission operating temperatures, and eventual failure. To prevent this we recommend changing your filter, fluid, and seals to ensure your transmission continues to operate flawlessly. We recommend filter and fluid changes every 50,000 miles.

Kit Includes:

• Automatic transmission filter with associated hardware
• Oil pan gasket
• Drain plug with sealing washer
• Fill plug with sealing washer
• 7 quarts Redline D6 automatic transmission fluid

Fits the following BMWs:
E82/88 BMW 128i - with GA6L45R automatic transmission 
E83 BMW X3 N52 3.0L - with GA6L45R automatic transmission 
E9X BMW 328i/xi  - with GA6L45R automatic transmission