Intercooler for BMW 4 Series F32 (2014+)

Engines make more power when you're able to move as much air and fuel as possible through them. However, air density is just as important as air volume. Cooler air is denser air, so in addition to keeping your engine cool, it's important to make sure that your intake charge is as cool as possible. Turner Motorsport's upgraded intercooler works to reduce air temperatures with a bare minimum of pressure drop. Less pressure drop means less restriction, and a turbocharger that doesn't have to work as hard. This results not only in a longer service life for your turbocharger, but a substantial increase in performance as well.

The stepped design increases volume and surface are in a limited space by adding an additional smaller core at the top of the intercooler. Both cross sectional area and frontal surface area are increased by a whopping 56%, with a design that still weighs under 20 pounds. On the stock intercooler, the temperature differential between the inlet and outlet sides of the intercooler represented a 95 degree drop. With the Turner Motorsport intercooler, that drop was increased to a chilling 140 degrees. The dyno results don't lie: as a bolt-in upgrade, expect gains of 18 wheel horsepower and 10 lb/ft of torque. With a tune and supporting modifications, further gains are possible, up to 36 horsepower and 28 lb/ft of torque.

This cast aluminum intercooler features an attractive, easy to clean matte black finish, with etched Turner logos on the front and bottom. If you're looking for the ultimate cooling system upgrade for your turbo BMW, look no further.

• Cast aluminum construction
• Bar and plate design
• 56% increase in frontal surface area & cross sectional area
• Decrease in temperature of 45 degrees from inlet side to outlet side (95 degree drop stock on outlet side vs. 140 degree drop on Turner outlet side)
• Significantly less restriction (pressure drop of consistently 0.75 psi vs. 1.5-2.5 psi stock)
• +18HP/10TQ (+36HP/28TQ with tune and supporting mods)
• Weighs under 20 lbs.
• Overall size: 520mm wide, 210mm tall
• Mounting hardware inlcuded

Upgrade to the following OE Intercoolers: 17517600531, 17517600530, 17517618809

Fits the Following BMWs:

F22 F23 228i 228i M235i M235ix

F30 F31 F32 F33 F34 F36 328i 328ix 335i 335ix 428i 428ix 435i 435ix

A performance intercooler is a must when looking to get the most performance possible from your vehicle. Stock intercoolers are great for daily drivers but don't quite meet the demands for airflow and cooling when used on the track. CSF is here to remedy this situation with their all new High Performance Intercooler.

CSF has built up a reputation for themselves as one of the top contenders in the aftermarket community for performance cooling. With the success of their side mounted intercoolers for the S55 engine in the F8X M3 and M4, they have shifted their focus to the N55 and N20 platform. Their designs are a tried and true method using a bar and plate, stepped core intercooler. This, combined with the naturally high build quality of CSF products, will enable this motors to freely pull a much greater amount of air into the intake all while keeping things cooler than stock. This allows the engine to build power all throughout the RPM-band without the restriction that would normally start to be seen above 4500 RPM.

Features:

• Stepped core design for maximum surface area contact and internal intake air-flow volume. Largest “drop-in fit” intercooler available in the industry.
• Designed with 3D scanning / rapid prototype technology to ensure precise fitment and maximum surface area utilization. Lab tested on CSF’s in-house wind tunnel.
• Rounded front face bar/plate design for optimized airflow through the core. *A CSF World Exclusive*
• Drop-in fit” design for an easy & quick plug-and-play installation. Complete with OEM style “Quick-Connect” inlet/outlet connections.
• Fully reversible back to OEM spec with no modifications needed.
• ~40 *F drop in temperatures when compared to the OEM intercooler after multiple repeated runs.
• Power increase of 15-20 hp on stock cars, 25+ hp on modified vehicles.
• Available in silver (#8115) and matte black (#8115B)
• Lifetime warranty.