Packaged by Turner for BMW 3 Series E46 (1999-2005)

When replacing your worn out brakes, the market is flooded with performance options. If your BMW doesn't see track time, it's not very practical. Performance pads and rotors tend to result in a lack of bite at low braking temperatures and cause excessive noise in daily driven vehicles that becomes irritating. BMW brakes from the factory are perfectly suited for trips around town, across the country, and even the occasional spirited driving session, delivering smooth, quiet, and long lasting performance. 

Included in this E46 BMW brake package are all of the OEM equivalent components needed to replace your Front and Rear brakes with comfort, reliability, and optimal lifespan in mind.

Brake components in this kit:

• Textar Front & Rear Brake Pads
• Zimmerman Front & Rear Rotors
• Febi Front & Rear Wear Sensors
• Brand New Stainless Steel Set Screws
• Syl-Glide Silicone Brake Lubricant 

Fits the following BMWs:
1999-2006 E46 BMW 323i Touring, 323Ci Convertible, 325i/Ci 328i/Ci

Eliminate the most common sources of suspension slop with our all new Turner Suspension Refresh Kits that feature only OEM parts! We do not include any "cheap parts" in our refresh kits to ensure long-lasting reliability and noise-free suspension.

This Level 2 kit replaces:

Control Arms & Bushings
Outer Tie Rods
Sway Bar End Links
Upper Strut Mounts & Reinforcement Plates

Often an oversight in maintenance, ignition components are also susceptible to wear and tear. Spark Plugs can accumulate carbon, reducing the spark intensity and it's ability to properly ignite the air/fuel mixture, leading to misfires and generally declining performance. Other ignition components, such as coils, boots, wires, caps, and rotors, can also wear out over time due to factors like heat and contamination, preventing the current from reaching the spark plug.

To start over fresh with all new components, we now offer these Ignition Service Kits. Each kit comes with brand new OE quality components, replacing any potential fault points in your ignition system for peak performance!

See kit contents below for a complete list of included components.

Fits the following BMWs:
E46 BMW 325i/Ci/xi 330i/Ci/xi M54 (09/2002+)
E53 BMW X5 M54 (10/2002+)
E39 BMW 525i 530i M54 (09/2002+)
E83 BMW X3 M54

Drive line slop is often caused by faulty engine and transmission mounts. This can result in knocking noises under heavy acceleration, excessive vibration, and a less responsive feel in power. These OEM Febi and Lemforder mounts are perfect to eliminate these problems and provide long lasting reliability.

Included in this kit:

• OEM Febi Engine Mount (x2)
• OEM Lemforder Transmission Mount (x2)
• New Installation Hardware

Over time, accessory belts begin to wear out and crack. This can lead to the belt slipping, squeaking, or even snapping. Replace your belts and tensioners on a regular basis to ensure you don't end up stranded on the side of the road with a dead battery or over heated engine due to a bit of simple overlooked maintenance. This kit includes all of the items that will need replaced such as the belts, tensioners, and hardware.

Fits the following BMWs:
2000-09/2002 E53 BMW X5 M54
2000-09/2002 E39 BMW M54
1999-09/2002 E46 BMW M54

When replacing your worn out brakes, the market is flooded with performance options. If your BMW doesn't see track time, it's not very practical. Performance pads and rotors tend to result in a lack of bite at low braking temperatures and cause excessive noise in daily driven vehicles that becomes irritating. BMW brakes from the factory are perfectly suited for trips around town, across the country, and even the occasional spirited driving session, delivering smooth, quiet, and long lasting performance. 

Included in this E46 BMW brake package are all of the OEM equivalent components needed to replace your Front brakes with comfort, reliability, and optimal lifespan in mind.

Brake components in this kit:

• Akebono Euro Front Brake Pads
• Centric Front Rotors
• New Front Wear Sensors
• Brand New Stainless Steel Set Screws
• Syl-Glide Silicone Brake Lubricant 

Fits the following BMWs:
2001-2006 E46 BMW M3 (Non-CSL/Competition Package)

When replacing your worn out brakes, the market is flooded with performance options. If your BMW doesn't see track time, it's not very practical. Performance pads and rotors tend to result in a lack of bite at low braking temperatures and cause excessive noise in daily driven vehicles that becomes irritating. BMW brakes from the factory are perfectly suited for trips around town, across the country, and even the occasional spirited driving session, delivering smooth, quiet, and long lasting performance. 

Included in this E46 BMW brake package are all of the OEM equivalent components needed to replace your Front brakes with comfort, reliability, and optimal lifespan in mind.

Brake components in this kit:

• Pagid Front Brake Pads
• Zimmerman Front Rotors
• Brand New Front Wear Sensors
• Brand New Stainless Steel Set Screws
• Syl-Glide Silicone Brake Lubricant 

Fits the following BMWs:
E46 BMW 330xi

The E46 3-series can really benefit from a slightly firmer suspension. The stock shock and spring package is a bit too soft and mushy with a lot of bodyroll. Even the factory sport suspension was a marginal improvement. If you have been left wanting more from your stock suspension, this is the perfect upgrade. In this E46 shock and spring package we paired H&R Sport springs with a set of Bilstein sport shocks and struts to deliver a package with near-stock levels of comfort but with stiffer springs that improve handling and lower the ride height for better aesthetics.

H&R Sport springs lower the ride height by up to 1.4" in front and .75" in the back and stiffens the spring rate. Both combine to lower the car's center of gravity and reduce the amount of bodyroll in corners. The springs are progressive rate so their initial stiffness is actually very compliant and it becomes stiffer as the spring is compressed. This is great for street cars that see bumps and potholes where suspension compliance is key. Overall, they are about 30% stiffer than the stock original springs.

We use Bilstein Sport shocks as the dampers and they feature Bilstein's patented and innovative valving system. With this system, small bumps and impacts are absorbed as they should be. But the shocks stiffen for cornering and other suspension motions. It's the best of both worlds as the shock self-adjusts based on suspension motion. These fit with the stock strut and shock mounts, making for an easy and clean install.

Ride height varies by stock suspension:

E46 standard suspension: F: -1.4: / R: -0.75"
E46 sport suspension: F: -0.75" / R: -0.25"

Parts list:

• 1 set - H&R Sport Springs (29485 or 29484)
• 1 - Bilstein Left Front Sport strut (35-115106)
• 1 - Bilstein Right Front Sport strut (35-115113)
• 1 pair - Bilstein Rear Sport Shocks (24-027250)

This item fits the following BMWs:
1999-2006 E46 BMW 323i 323ci 325i 325ci 328i 328ci 330i 330ci sedans and coupes

Maintaining proper oil levels in your engine is crucial for peak performance. Undetected leaks can cause your oil to drop to dangerously low levels between oil changes, leading to severe engine damage.

One common culprit for oil leaks is the valve cover. Over time, exposure to extreme temperature fluctuations can wear down the gaskets, causing them to fail. Prevent oil leaks and protect your engine by replacing these vital components.

Comprehensive Kit Includes:

Valve Cover Perimeter Gasket Valve Cover Spark Plug Tube Gaskets 15 Rubber Grommets/Sealing Washers Ultra-Black RTV Gasket Maker Replace your old gaskets with our high-quality kit to keep your engine running smoothly and efficiently.

Eliminate the most common sources of suspension slop with our all new Turner Suspension Refresh Kits that feature only OEM parts! We do not include any "cheap parts" in our refresh kits to ensure long-lasting reliability and noise-free suspension.

This Level 1 kit replaces:

Front Control Arms
Front Control Arm Bushings
Front Ball Joints

Often an oversight in maintenance, ignition components are also susceptible to wear and tear. Spark Plugs can accumulate carbon, reducing the spark intensity and it's ability to properly ignite the air/fuel mixture, leading to misfires and generally declining performance. Other ignition components, such as coils, boots, wires, caps, and rotors, can also wear out over time due to factors like heat and contamination, preventing the current from reaching the spark plug.

To start over fresh with all new components, we now offer these Ignition Service Kits. Each kit comes with brand new OE quality components, replacing any potential fault points in your ignition system for peak performance!

See kit contents below for a complete list of included components.

The perfect upgrade for any E46, this finned differential cover increases cooling to the rear differential to prevent over heating and possible damage. This is a complete kit including fluid and drain plugs.

Includes the following

• Aluminum finned differential cover
• Drain & fill plug with sealing o-ring
• 2 Quarts of Redline 75w90