BMW Engine Parts for BMW 3 Series E93 (2007-2013)

This is the OEM Bosch ignition coil that is the current replacement for most BMW 6 and 8-cylinder engines built since 2003. It's listed as a replacement coil for M54, M56, S54, N52, N54, N62, N63, N73, S63, S63TU and other engines. BMW has made numerous changes to ignition coil part numbers in recent years but has approved this part number to work in the vehicles listed in our fitments tab. This part number replaces previous BMW part numbers 12130390064, 12130148594, 12131712219, and 12137551260.

Ignition coils are key to the efficiency and performance of your BMW. With a faulty coil the spark plug is not burning the air/fuel mixture properly and that can lead to problems anywhere in the engine and exhaust (including catalytic converters and O2 sensors). Problems with one or more coils will cause a fault code but not always a check engine light. A misfire code may be related to an ignition coil but could be from other things as well. Sometimes a visual inspection of a coil and coil boot will give an indication of a failure. You can also move coils around to different cylinder banks to see if the misfire code follows a suspect coil. We suggest always having one or two coils on hand to keep as spares.

This Bosch part also satisfies BMW's service bulletin for 2001-2003 E46 M3 ignition coils (SIB 12 24 05). That SIB calls for Bremi or ERA brand coils but BMW has replaced them with this Bosch design.

Bosch is one of the largest OEM producers of Genuine BMW and aftermarket parts in the world, providing parts for almost every major automotive manufacturer. Bosch has likely supplied many of the original electrical (and mechanical) parts for your BMW. Thanks to their quality, high durability, and reliability, you should expect a long service life from Bosch products.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

Sold per coil. Includes connecting boot.

Ensure the correct voltage is being sent to/from the alternator, keep you electrical system safe from excessive voltage peaks that could cause damage to sensitive electronics and blow out fuses. Bosch's high quality unit will give you peace of mind knowing the electrical system will be safe and the voltage will remain steady. OEM replacement for BMW part # 12317561939

Bosch is one of the largest OEM producers of Genuine BMW and aftermarket parts in the world, providing parts for almost every major automotive manufacturer. Bosch has likely supplied many of the original electrical (and mechanical) parts for your BMW. Thanks to their quality, high durability, and reliability, you should expect a long service life from Bosch products.

As a leading source of high performance BMW parts and accessories since 1993, we at Turner Motorsport are honored to be the go-to supplier for tens of thousands of enthusiasts the world over. With over two decades of parts, service, and racing experience under our belt, we provide only quality performance and replacement parts.  All of our performance parts are those we would (and do!) install and run on our own cars, as well as replacement parts that are Genuine BMW or from OEM manufacturers. We only offer parts we know you can trust to perform!

The oxygen sensor is vital to the performance and drivability of your car. The engine computer relies on data from the sensor to make adjustments in engine efficiency and performance. When your BMW oxygen sensor fails, the computer can no longer sense the air/fuel ratio, so it ends up guessing -- resulting in poor performance, poor gas mileage, and increased pollution. Make sure your BMW engine performs as it should, and doesn't use more fuel than it needs to, by simply changing your oxygen sensor today. There is no lifespan on O2 sensors but there are several fault codes that indicate a failed sensor (O2 monitoring, cat efficiency, O2 heating circuit, O2 readiness, and others). The O2 sensor is heated and has a self-calibration feature so once you get the codes or feel performance has suffered, a new sensor is a good starting point to get you back to peak performance.

This is a Bosch O2 sensor - also known as a Lambda probe. Bosch is an OEM supplier to BMW.

Position: after the catalytic converter (post-cat).

This item fits the following BMWs:
2008-2013 E90 E92 E93 BMW M3 Sedan, Coupe, Convertible

Enhance the durability of your BMW E9X M3 (S65) engine with the Slon Workshop Vanos Covers Kit. The OE plastic vanos cover is known for cracking and failure, posing a risk of plastic debris in the engine. Replace it with the IND Slon upgraded vanos covers for added peace of mind, preventing potential issues and ensuring the longevity of your engine.

• Vanos Covers Kit for BMW E9X M3 (S65)
• Upgraded design for enhanced durability
• Prevents cracking and failure of the OE plastic vanos cover
• Reduces the risk of plastic debris in the engine
• Provides an extra level of peace of mind for engine safety

BMW N20 N52 N55 Timing Chain addresses the common issue of timing chain stretch and rattling over time. Although BMW designates the timing chain as a lifetime part, many enthusiasts choose to replace it preemptively. Turner Motorsport offers this direct-fit replacement for those needing to replace a worn or damaged timing chain without opting for a full kit.

• Direct Fit Replacement: Perfect for replacing a stretched or broken timing chain.
• High-Quality Construction: Ensures durability and reliability in maintaining engine timing.
• Ease of Installation: Designed to fit precisely without requiring additional modifications.
• Ideal for Maintenance: A practical choice for enthusiasts who prefer to change the timing chain independently of a full kit.

The factory magnesium valve covers on the S65 engine are known for developing micro-porosity, corrosion, and persistent oil leaks over time. This material is highly susceptible to oxidation, leading to unsightly surface imperfections, weakened gasket channels, and sealing issues that a simple gasket replacement won't fix.

Upgrade to this high-strength aluminum valve cover, engineered as a direct-fit replacement for your aging OEM covers. Unlike magnesium, aircraft-grade aluminum offers superior durability, enhanced heat resistance, and complete immunity to the corrosion issues that plague factory covers. Whether you're refreshing a high-mileage M3 or seeking long-term reliability, this upgrade ensures a leak-free, worry-free solution for your S65.

This valve cover includes gaskets, bolts, and the oil separator for a comprehensive replacement.

Features:

Eliminates the common porosity and corrosion issues found in factory magnesium covers.

Helps maintain optimal engine temperatures and enhances long-term reliability.

Gloss red finish provides a much-needed boost in engine bay aesthetic.

Designed for an OEM-like installation without modifications.

Reduces the risk of oil leaks, ensuring a proper seal.

Resistant to oxidation and chemical exposure for a long-lasting clean look.