BMW Engine Parts for BMW 3 Series E46 (1999-2005)

This top-end gasket set covers the cylinder head on the S54 engine used in the E46 M3, Z3 M Roadster/M Coupe, and E85/E86 Z4 M Roadster, M Coupe. If you're pulling the head, intake manifold, or doing any other upper end engine work this set can be a time and money saver. This set includes all of the commonly replaced gaskets, seals, and o-rings when overhauling the head. It's also a useful kit to have and dip into any time you're doing upper end engine work. Not having a critical seal or gasket on hand can ruin your work and this gasket set can prevent that from happening. This Victor Reinz set includes the head gasket.

BMW #QtyDescription

071199035461left timing rail upper bolt seal

071199630724VAN0S oil line seal ring

071199631292crankcase vent banjo bolt seals

071199632522screw plug seal ring

071199633421right upper timing rail bolt seal ring

071199634181timing chain tensioner seal ring

111214373952valve cover stud grommet seal

1112783097213valve cover stud grommet seal

111278312716spark plug hole profile gasket

111278320341main valve cover gasket

111278370241oil fill cap seal ring

111278370251crankcaske oil separator seal ring

111417367581VAN0S-camshaft plate o-ring

111578309661crankcase oil separator o-ring, large

111578321191crankcase oil separator plug o-ring

113113173181inside o-ring for internal VAN0S regulating valve

113490644572valve stem seal, 2 sets = 24 valves

113678319381VAN0S unit profile gasket

114113060821outside o-ring for internal VAN0S regulating valve

115313184021thermostat-to-water pump o-ring

115378307083coolant pipe o-ring gasket

115378307092thermostat housing connector o-ring

116114076951intake bellows o-ring profile gasket

116178301041intake bellows-to-airbox gasket

116278306676exhaust manifold port gasket

117275052591air pump valve profile gasket

121417483982camshaft position sensor o-ring

135478314836throttle body o-ring

136414374746fuel injector o-ring, upper

136478306116fuel injector o-ring, lower

111278359181head gasket

This item fits the following BMWs:
2001-2006 E46 BMW M3
2001-2002 Z3 BMW Z3 M Roadster Z3 M Coupe
2006-2008 E85 BMW Z4 M Roadster Z4 M Coupe

This set of top-end gaskets is a both a time and money saver. It includes all of the commonly replaced gaskets, seals, and o-rings when pulling the cylinder head for overhaul. Having these on hand instead of chasing them down at the last minute will save you time, money, and frustration. With the head off the car you're going to want or need to replace these items anyway to ensure it's free of fluid and vacuum leaks. This is especially important because the newer BMW models have very strict emissions controls and vacuum and oil leaks can create turmoil in the system. Even if you're not pulling the head this set includes so many valuable parts you'll want to keep this on hand to use for spares.

This item fits the following BMWs:
2003-2006 E46 BMW 325i 325ci 325xi 330i 330ci 330xi
9/2002-on E39 BMW 525i 530i
2004-2005 E60 BMW 525i 530i
2004-2006 E83 BMW X3 2.5i X3 3.0i
2003-2006 E53 BMW X5 3.0i
9/2002-on Z3 BMW Z3 2.5i Z3 3.0i
2003-2006 E85 BMW Z4 2.5i Z4 3.0i

The alternator in your vehicle keeps the battery at full charge when your engine is running. Because all of your electronic systems run off of this small piece, it's important that it is operational. If your lights are dim while driving or your battery dies within minutes of starting your car, it's time for a new alternator.

This is a NEW alternator from the OEM manufacturer, Valeo. No core charge applies. Valeo is an OEM manufacturer for many BMW alternators - save money by buying the same alternator in a different box!

Since getting their start in 1981, Active Autowerke has earned a well-respected reputation in the BMW community for engineering high-quality power solutions for popular BMW models. This supercharger kit will produce 425 horsepower and 295 ft.lbs. of torque on your BMW, while retaining platform integrity and daily driveability. Unique to the design of the Rotrex supercharger is the traction drive system, which eliminates the lag often found in other centrifugal supercharger setups. Power delivery is smooth and dependable, and 100% reversible to stock if you so choose, since each system is designed as a self-contained unit. best of all, when you crave more power, this kit is fully upgradeable to Level 1 and Level 2 specs.

Kit features:

• Rotrex C38-92 trim supercharger running 5.8 PSI of boost
• Active Autowerke GEN 7 intake manifold
• Active Autowere dual blow-off valve setup
• Active Autowerke Air Filter
• Alpha N software tune w/ SIMON2 interface
• 6 high-flow fuel injectors
• Dedicated oil cooling system
• All mounting hardware, plumbing, hoses, & clamps
• Illustrated instruction manual & installation guide
• 2 year warranty with free tech support

Base Prima supercharger Dynojet results:
Boost: 5.8 psi
Stock Horsepower:  285.4 WHP @ 7500 RPM
Stock Torque: 232.36 LB-FT @ 5250 RPM
Supercharged Horsepower: 426.69 WHP @ 8150 RPM
Supercharged Torque: 297.99 LB-FT @ 7200 RPM