Emmanuele Design Lowering Spring Set - F80 M3

Product Details

Using a linear design (similar to OEM) with unique spring rates, Emmanuele Design's lowering springs are properly matched to the factory dampers, ensuring a ride quality that is slightly stiffer than stock, but predictable in nature. A progressive spring will typically be softer at light loads, then dramatically stiffen as compression increases. This makes it very hard to match dampening, and creates the bouncy feeling over light bumps. The linear design of these springs have a consistent rate as the spring sees higher load. On light bumps, it will allow the chassis to follow the road well (minimizing the bouncy feeling), while under heavy compression it will stiffen to prevent bottoming out. In our experience, this creates a much better overall ride quality.

Compatible with adaptive suspension.

Each spring set is 100% made in the USA exclusively for Emmanuele Design. The springs are made of high tensile chrome silicon and each unit is shot peened, pre-set and 100% tested to insure all the critical dimensions and rate/loads are within tolerance. The springs are then powder coated with a stealth black finish for an OEM appearance. The use of high tensile chrome silicon, as opposed to typical commercial grade chrome silicon, allows us to create a lighter spring that can sustain repeated deflection without deformation. High tensile chrome silicone will typically have thinner coil diameters that are spaced further apart, when compared to commercial chrome silicon.

Prop 65 Warning

Product Q&A

Lifetime Replacement

Fits These Cars