Shark Injector Performance Software

Product Details

If you're looking for the easiest way to add power and torque to your BMW, a Shark Injector is answer to your prayers. Dyno-tuned by BMW tuning legend Jim Conforti, this software are designed to make the most of high-octane (91+) pump gas and boost mid-range torque and high-RPM horsepower. To make the most of these improvements, the rev limit is raised, and fuel and spark maps are fine-tuned to make your BMW perform better than it did when it left the factory. There is no downside to installing a Shark Injector - it's specially designed to safely improve performance, while maintaining driveability and improving responsiveness. All units are shipped with detailed instructions and are typically installed in an hour - a true plug-and-play performance solution.

Installation is easy. Just plug in a battery charger to provide backup power to your car battery, plug in your Shark Injector, and push the button to start the process. The Shark Injector replaces parts of the stock software, while storing the original data in the unit for later use if needed. When the LED goes from red to green, you're ready to start enjoying your BMW's new performance!

BMW's M54 engine is a finely-tuned machine, but there are still plenty of opportunities to improve the driving experience. Jim Conforti tuned this Shark Injector to produce an additional horsepower and torque, while improving engine response and raising the rev limit to 7,000 RPM and removing the speed limiter, unlocking the full potential of your BMW. Enjoy a vastly improved driving experience, especially under part-throttle and wide-open throttle acceleration.

Not for sale or use in the state of California on any pollution-controlled vehicle as per the California Air Resources Board.

Prop 65 Warning

Product Q&A

Lifetime Replacement

Fits These Cars